Bung King Kickstand Lift Block

Installed 1” block after upgrading my suspension to 13”. Had to do a bit of grinding on the lockdown leg for the bolt to sit flush.Be prepared to go through some drill bits. Start small and work your way up to 1/4

Great quality

This is an inexpensive alternative to buying an all new side stand (jiffy stand). I added a +2 spring and fork tube kit to the front and 14" shocks to the rear of my Road Glide and knew that I'd need a +1 jiffy stand, but decided this block was the better alternative. All you need to do is take the jiffy stand off, wrap it in rubber/piece of leather etc., place it in the vise, and use the template Bung King provides to drill the required holes in the foot of the jiffy stand. After that, I put a little red Loctite on the the threads of the included machine screws and installed. This is better than paying $60-$80 on a new jiffy stand only to have throw your perfectly good stock one in the trash, or have it laying around collecting dust.

So looks to be made of 5051 aluminum, not stainless steel. It's also solid and not milled out like the taller block they sell. On some surfaces it scrapes off a small bit into the concrete .It's not an exact fit for my road glide but a bit of grinding will fix it or a shim between the block and the kickstand. I had to shift it over a bit due to the oem lever welded the way it is. I ended up drilling and tapping my own 1/4-20 threads in the block.It also sticks down below the frame when it's in the up position, it shouldn't be a problem unless you encounter a tall speed bump.If I had known it was aluminum amd didn't fit correctly, I would have gone my own way.

Bought a 2023 CVO Road glide and the lean angle is way different than my previous Road Glides. It was almost impossible to get the bike up when parked on a slope or grade. Frustrating, because I had never had this issue before. Purchased the 1” block, easy to install, and it made a world of difference! Fits the jiffy stand perfectly. Highly recommend!

Installed on my 83 FXR, it leaned way too far. Could have used a little taller one but it helped a lot.

Just received mine haven’t installed it yet. But should be east to do with the template… however now I need to make an unexpected trip to the hardware store to buy the screws that are pictured with it that it didn’t come with. Not completely thrilled by that

The 2” comes with screws, the 3” did not. The block comes predrilled and tapped. It really helps reduce the lean of the bike with the 21” wheel vs 19” wheel. I might even install the 3” block “if” I find the lean is still to much. Need winter to go away so I can ride and truly test functionality.