Kuryakyn3163 Motorcycle Accessory: Curved License Plate Mount for 2006-16 Harley-Davidson Motorcycles, Chrome

Good Quality Product that looks great.Caution: Removing the tail light will take patience. It’s not too bad if you have 1/4 Ratchet set or 1/2 Ratcheting Wrench.Caution: Assembling the License Plate takes patience. Take your time and get a good line up. The supplies screws are pretty short. They will work but it might be better to get longer bolts. They are 1/4” Threads. I bought some that were 3/4 Inch long and that worked out perfect.Otherwise this is a great addition to your look of your bike.

I love when the paint matches. License plate holes did not line up but plate wasn't made the best. Little trim and bigger holes took a few extra minutes. Would like black screws better but I'll get over it. Love the look, really cleans up the rear fender. Took about 20 minutes to install on a 2022 SG Special.

All I'm going to say is the install was easy for me because I was changing my rear fender after being rear-ended by a Red Corvette. It may be a challenge if you're just switching out your old setup. But at the end of the day it was well worth it. I love the clean appearance of the curved plate holder. Was it worth the money? Well you get what you pay for. Rather purchase a Kuryakyn than some knockoff.

Pricy for a plate holder but made of high quality material and looks great on the bike.

Time will tell… I bought this license plate holder to replace the OEM part. I had to replace the OEM part TWICE in TWO years because vibration from the motorcycle stressed the license plate holder to the point where it would crack near the fastenings. On the first occasion, the OEM holder cracked completely and I would have lost my license plate had I not heard it hit the pavement. I noticed that the second/replacement OEM holder had partially cracked while I was cleaning the motorcycle. The Kuryakyn license plate holder seems to be made of much better material, and it certainly looks a lot classier. Included with their kit, is a foam rubber pad that fits between the bottom of the license plate holder and the fender. This pad is intended to absorb vibration. Only time will tell if the Kuryakyn license plate holder will hold up, but, for now, I will give it five stars.

It looks great on the bike, not very much to the install

Good quality fast delivery..allen key head diameter is too big..a bit offset. Overall quality very good.

Cant beat the look of this plate holder i installed without a jack and believe me you have to be patient especially trying to get your hands up in your fender area to reach the nuts. A small 1/4 in ratchet worked best. Once its installed WOW really compliments your bike

Easy to install, looks awsome.

Just what the bike needed to clean up the back end, perfect fit. Canadian plate will need to be trimmed when installing. Worth the effort.

Easy to order... realitivly fast shipping considering the pandemic situation. Product looks great b

Good product. Might black out the scews one day. i would of bought the harley one but they were on back order for 6 months so went with this one and its good quility.Easy installation!

easy to install