Comfort Zone 10,000W Hard-Wired Garage Heater – Industrial & Commercial Ceiling Mount, 240V Fan-Forced Heater with Remote, Digital Thermostat, Timer, 2 Heat Settings, Overheat Protection, Grey

Got mine installed and did not have the hinge rear to drop access to the wire hookup area. Simple install to the garage ceiling with a pilot hole for a 2" long, 1/4 in width wood hex head with nice big flat washers to support the single center attachment point to the garage ceiling. Ezy pzy and plenty secure. I wanted to be able to turn the fan direction if wanted. Ran 10 ga 2 wire with ground to it from the QUALITY dryer plug bought here at the Zon, and wired the unit. I set on heat level #2 and turned it on. Excellent HOT heat coming out, and 12 feet away the fan is clearly doing it's job. The fan power is fine, the heat is HOT just set on 2, and the only potential drawback for some is the thermostat is not as accurate in function as your whole house furnace is. Who cares? Most are using this for a garage or shop, and some don't want those to drop under freezing when unattended and unused. I set up a remote temp sensor and in a 12 x 25 ft garage, in Omaha NE and if you want to keep your garage above freezing, this unit can do that. Really, it can do that not working very hard. I was thinking this was a big toy, might help a little or might not. I was wrong. This is a serious tool, well made, works, hot heat and fan plenty strong - and all at $109? Are you kidding me?? Can see other uses for this heater, too. This is NOT a toy, works, HOT heat, good fan, makes a bit of mild fan noise but WHO CARES? You sleeping in your garage? I got the ex warranty so if this goes South I'm covered, but by any account this is a nice unit, works, built solidly and if you do your own wiring be SAFE and be SURE to use a GOOD dryer plug with a lot of surface contact to your 10 ga wire. Critical. Tight and solid good connections is important. Get your gas cans out of your garage and into the shed. Read directions and adhere to them. They're there for a reason. My garage ceiling is only 7" but I attached this as high as I could right to the ceiling joists, center factory attachment point with big flat washers to help support. VERY impressive heater at this price point!!! Nice. My only nitpick is they should have made the ground attachment point the same as the two positives, with easy secure attachment. I used the extra wide wire crimper tool to secure a yellow 10ga wire loop to the end of the ground wire, then attached that to the ground point on the unit where they supplied the hex head bolt attachment. Works fine. Just UN-necessary and their trying to maximize profit by saving a buck a copy. No bid deal. GOOD UNIT. PS: The Zon 10 ga 2 wire and one ground wire pricing was way better than the big store big name hardware stores here!!

Nice garage heater. It's quite and throws heat well. I'm using it in a 20' storage container to maintain heat and it holds a steady temperature day and night.

It would be a 5-star if I had a smaller garage; it is definitely doing its job. For a larger 3-car garage in the Midwest winter, for example, it's 14 outside, and the garage is a warm 55. I would give it five stars if it were a little quieter when it kicks on and a little more efficient thermostat. Again, I love it. If you have a 2-car like my father, who I bought one for, it's 5-star all day long. A 3-car is pushing it a little harder unless you want to run it over 65-70 in the Midwest winter.

Works perfect in Our new 3rd stall garage. We installed a 12x24 attached 3rd stall and needed a heat spruce for the midwestern winters. The heater heats up fast and is easy to install. This is perfect size and out of the way for my husband’s woodworking shop. If only it came with a remote or a swivel so you do t ha e to do it manually.

I was skeptical of this heater at the price. It seemed too good to be true, but I bought it anyway and am glad I did. I had some an unused 240v 30 amp fuse on my garage panel and some 10gauge wire in flexible conduit, so I had it installed shortly after it arrived. It heats my insulated 250 sq/ft shop in Northern Wisconsin on the 3000 watt setting in about an hour. According to my math, it would cost 6 bucks at this setting to run 24 hours. I don’t imagine I will ever need to run more than 4 hours at a time. If it lasts, this is a great little heater.

This thing really saved me when I forgot to order propane and had to get by for a while on a second home during the coldest temps of the year. I was worried about some of the bad and scary reviews but it has been working great. The install wasn’t too bad but expect to pay another $150 in installation materials. First thing I noticed when I started it was that the fan was pretty quiet and the temps were not too hot. This made me feel better about an overheating and fire issue. I installed it in my basement of a 3700 sqft house when the basement is included. I closed off some bedrooms and was able to get 54 degree temps on the first floor and 58 degrees in the basement. I lowered the temp to the point that the heater could keep up and have some time cycled off. Turned out to be 55 degrees. Outdoor temps were below 1 degree F. I altered the install to make it temporary for now. Hung it from a metal shelve and positioned under my duct work to be fire safe. Also ran the wire directly above so that any fire would melt the casing and short the wire, causing the breaker to trip. The thing I forgot to do was move my WiFi smoke alarm nearby. I wanted WiFi control of the heater since I would not be there so I ran an incandescent night light and tie wrapped it to the heater back by the thermostat. I plugged it in to a Kasa WiFi plug so I could schedule or turn on and off at will. It made the thermostat read 74 degrees, lower than my set temp which would trick it into turning off. It was a 7 watt bulb. Then I put a camera on it all with a motion sensor (Simplisafe) so I could check on it. After a few days I felt pretty good about it. Any fire should be relatively contained. The alarm camera would notify me and I could turn it off via the night light. Should that fail, the wire would be first to go and turn off power. Since it was just metal and concrete, it shouldn’t be an issue.

Unit is quiet and with 7.2 KW it puts out great heat . For The price its a good unit

Installed the heater in my 500sqft garage with R12 insulation and it works great. I think it could be better if I bent the fan blades a bit more to increase air movement but honestly, it is just fine. I use an additional fan mounted up by the ceiling to circulate more air and it helps get the heat off of the ceiling. I connected my heater to a 2 pole 30A switch so I do not need to access the controls and it works like a charm. Highly recommended.

Still toying with it but so far the thermostat switch does not seem sensitive enough to hold a steady temp. I have used this heater for a while now and I am very satisfied with the performance. I switch it on the middle setting for about an hour before going into the shop/garage and can expect 12-15 degrees on a cool west coast (6-7 degree) day. I necessary I'm sure I would be able to satisfactorily heat the 400' space in much colder weather.

This works so well. Easy to use. And like the remote. Would be nice if connected to wifi

chaufer un atelier ce produit est exellent !