HICARER 2.8 Inch (70 mm) Roman Numeral Quartz Watch Insert with Gold Trim

Bought as a replacement for my Waterford clock that stopped working. As other have mentioned, had to wrap plastic wrapping around it to fit, but once that was done, it fits and looks great! So far, it is keeping good time

My original clock finally gave out and purchased this replacement. Fits perfectly in the desk pen set even though the unit is over 40 years old. Clock keeps accurate time, was inexpensive and looks like the original Danbury unit

Needed a dial replacement for my Waterford clock. This was a great alternative - great quality. It was a little loose but you can use a rubber band to make it fit.

Would have liked a bigger face but for my opening this one fit in prefect. Been hunting for a new one was years. Happy to finally have the clock working again. Slid right in place. Thank you

Good value for the money, it fits in an acrylic award from work. The original clock quit and made me disappointed that I did all the work to get that award and the clock was stopped. Simple, but it makes me feel better.

I was concerned that this clock might be too small for the 70mm opening in my Staiger crystal clock. It was, because the "works" behind the clockface were smaller than the 70 mm opening -- but I was able to make it fit snugly by wrapping two large rubber bands around the works -- and then covering the rubber bands with the rubber gasket provided with the clock. The clock fits perfectly, and the gasket masks the rubber bands, avoiding an unsightly mess. The replacement clock works well. I was not able to find a replacement clock for the Staiger anywhere -- without this clock, the Staiger would be in the trash. The gasket makes the difference.

My wife has an expensive Waterford clock. The motor stopped working. I purchased this clock for its motor instead of paying $40 for a Waterford replacement. You can carefully disassemble both clocks (use a tiny screw driver to push the Waterford glass out from both sides). You need to sand the top and bottom of this motor (bottom significantly) by rubbing it in a flat piece of sandpaper. Once you’ve got it sized correctly you need to snip off two tiny silver tabs/poles inside the Waterford clock base. The rest goes back easily. Beautiful replacement. I actually like these hands better (more elegant). Clock keeps perfect time.

Neither liked or disliked. Measurment instructions was misunderstood and product was incorrect size to fit need. Returned item. I am going to try to locate physical item at brick and mortar store to ensure proper fit.