Thermal Grizzly KryoSheet (68x51x0.2mm) – Ultra High Thermal Conductivity Graphene Thermal Pad – Perfect Alternative for Thermal Paste on CPU/GPU/PS4/PS5/Xbox – Made in Sweden

Quite expensive. But worth it, especially that you can re-use it (I assume) and saves you the mess of thermal paste

Needed to cut it with a blade to the size of my laptop chips. Satisfied with the thermal performance. Clear improvement compared to carbanaut pads.

This should be the new standard for CPU cooling I'm using it on My Ryzen 9 9950X and Ryzen 9800X3D with Noctua NH-D15 G1 and Noctua NH-D15 G2 the temps are so great probably 2c to 3c degrees lower than a standard quality thermal paste. Pros: - No more thermal paste mess - easy to use - Covers the entire CPU perfectly AM5 CPUs are 33cmx33cm - You don't need to change it or clean it or replace it it's stays there as long as you wish unlike thermal paste - Reusable just be careful when taking it off. Cons: * Be Careful when handling it the material is fragile so handle it with care. * Electrically Conductive "Nothing to worry about unless you are blind and put it somewhere else other than on top of your CPU lol" * Expensive "kinda worth it for me, but understandable" 100% Recommened over thermal paste.

ペラペラの紙に見えるが、これがよく熱を通す。 CPU周りが、汚れない。 ただ、CPUと水枕等の接地が均等ならよく熱を通します。 接地面に隙間が出来るようなら、シリコングリス等が良いかも。

I have tried a couple of oversize versions of this thermal pad which required cutting to fit. That turned into a disaster each time. The pads simply broke up either when cut with scissors or when slid around to position it on the CPU. They are quite fragile but it was my fault on both occasions. I thought I'd give it one more go with the correct size for my CPU being back in stock. This pad came with a small tube of silicone (the others didn't) that assisted the pad the stay in place when placing it on the CPU. So, no cutting and no worrying about the pad sliding around on the CPU now that it had a drop of silicone to hold it in place. The thermals for the CPU (Ryzen 9950x3D) have dropped 1 degree from the thermal paste that was previously used ie 39 degrees down from 40 degrees while idling. Not a great deal of difference but the fact that I shouldn't have to worry about the thermal grease drying out over time is a bit of a consolation. Expensive when compared to thermal grease but peace of mind will make up for that (hopefully!). At this point I recommend the Thermal Grizzly KryoSheet Graphene Thermal Pad and would use it in the future.

Works like a charm

Absolute worthless. Not 1 degree cooler then my paste that is 10 years old (fresh applied on cpu). So if you have paste don't do it. Waste of money. Yes i did all the steps correct. Wasted 20 euro.