Jumper Cable Clamps Compatible with Mil-waukee M18, 6.2FT 8AWG Portable Battery Jumper Starter Automotive Booster Cables Power for Car Jump Starting Using Tool

It fits the milwaukee batteries perfectly, so no problem with the fit. When I hooked up a multimeter - I got just over 18volts at the clamp ends. One thing that I like about the clamps - they are protected with plastic in such a way that the clamps cannot 'bump' into each other and accidently short out - so that is a good thing. Here are my concerns however. If you somehow 'short out' the cables while connected to a milwaukee battery what happens? I don't want to find out - but it could ruin the battery (and milwaukee batteries are not cheap) or even worse. There is no protection from short circuiting the batteries.Also - this is a 18v battery jumping a 12v system. This should be ok in an emergency - but again - use caution and do some research.Personally I think you should buy a proper jump starter battery built for this application. But... with all that being said - if you are in a real pinch - this will do the job.

Wiw these work better then expected! Easiest jump start. Even jumped our tractor which takes alot. Highly recommend

Its dumb, its only good for a few tries, and it saved my bacon a few times.

Wasn’t sure at first but then had to jump the lawnmower. When it fired right up, I was sold! Love it

They worked on an average car battery (almost fully drained) using a 5ah Milwaukee battery, however I tried jumping my 16’ Cummins off with an 8ah battery and it did not work. Still happy with it though for smaller applications. I’ll always keep it for a backup.Good build quality as far as the wiring goes too.

Why did you pick this product vs others?:Don’t waste your money, not built very well, does not work

My husband has used this twice since February to jump his work truck!! 👏 👏 👏

I use it with a 9 amp battery to start start my smaller tractors and welding machine