12 Pack Abrasive Blasting Cabinet Lens Cover - Clear Polyester Film Sandblast Cabinet Inner Len Protector Adhesive Standard Sand Blast Film for Abrasive Window Blasting Cabinet Replacement 23'' x 11''

Value for money:These are very clear, you just have to remember to take the film off of each side. Yes, the double stick tape is not pre applied but I don't care. I prefer not using double sided tape at all because I do a lot of blasting and go through a lot of these. I just use packing tape to tape them to the inside of my window frame. that makes them quick and easy to get on and off each time I need to replace them.

The size is accurate, the material thick and durable but unfortunately it's not clear it's translucent not transparent.If you're doing paint removal probably fine, if you actually need to see what you're doing this will not work.

These are clear. I run the tempered glass and a thin piece of polycarbonate underneath and one of these protectors on the under side on the polycarbonate and one on the the top side of the glass. Look at my Pic. All that and it's clear as you can expect. I would buy again if I ever run out. I'll get 6 changes and that should last a long time.

You have to apply the tape yourself. Tape is not pre applied to one side for you.

you have to peal off the protective layer and install the laminate tape yourself where others I have used are pre-assembled ... also note that the film is not as clear as other options for sale

Work good but don't last long, maybe couple days. Double sided tape included but it comes on a roll so a pain to install and line up to original. Pictures show tape installed but it's not. You have to peel protector film off the one side, then cut and install double sided tape, then place film on to your glass, then the other side has protector film to remove as well. Film and Double sided tape is hard to separate. Be prepared for an hour or two install job.

As the description says, it is "translucent". Just did not expect this cloudy. Also ships in roll form and has a permanent set that will distort the "flat" sheet when trying to install. If you already have a clear glass lens, then it might work at the reduced transparency. Also will probably work with intense internal lighting. Ours was delivered with a translucency equal to the old lens which was taken off after six months of use. Would not recommend for use with a worn lens or a non-glass lens. We are switching to tempered glass lens with polycarbonate inner shield. Save your funds.

not the clearest I have used better