45 Degree Chamfer Router Bit Set, 1/4 Inch Shank, Cutting Diameter in 1/2”, 5/8”, 11/32”, 25/64” C3 Carbide. Ideal for Angled Edges, Clean Edge or Decorative Pieces

The media could not be loaded. I really wanted / needed a new bit set that had an 1/8" round over, but these one comes with very useful bits 1/4 Inch Shank Versatile Round Over Edging Router Bit Set, 1/2", 3/8", 1/4", 1/8" Radius（4 pieces.I like the big bearings and the set comes individually pack and they are very easy to change or take off the bearing to clean up just using Allen wrench. These are a great value for four.I don't know how you can beat these router bits for the $$$. I've used them a ton, mostly on pine but on poplar which is harder and red grandis which is harder still.I've gotten good, clean cuts with them and they've lasted plenty long enough1. Definitely a good buy.

Not as sharp but workable have to get sharpeners

I'm very happy with these bits. I've been an avid woodworker for 20 years and have a large set of router bits, some of which are quite expensive. I wasn't expecting much for bits at this price, and I was pleasantly surprised! They cut very cleanly with no burning in hard maple, and the bearings work as well as any other bit I own (I almost didn't order due to reports of seized bearings). Each bit comes in its own plastic case, which was a nice plus for storing them with all my other bits.

They work great.

I've been using these simple router blades for a few months, mostly with my redwood hobbies. Work well with no problems.

These router bits work well in general: their sharp, the bearings are adequate to prevent burning as long as you keep them moving along the workpiece, and the shaft appears true. However there is a TERRIBLE flaw: the bearing his held on with a screw that can come loose. Rounding over the edges of a glued-up complex table leg assembly in the bench, and suddenly the bit dug into the wood sideways! Ugh. I stopped the router quickly and found the screw and bearing lying on the work table. Fortunately it occurred in a place that will be up under the table, so I filled it with plastic wood and (after reassembling the bit) routed that section again to shape the patch. If you buy these, I strongly recommend you disassemble the bits and reassemble with a strong thread locker like Loktite 277, and use a suitable torque on the screws to make sure they’re plenty snug.

Exactly as ordered!

For the price the bits look pretty good. I have not had a chance to use them yet, and test there longevity. The bits do not have any marking to indicate there size. Now you can figure it out by process of elimination from the pics of this product. Or compare them to old bits you might have. But someone new to this tool might have a hard time. Other than lack of labeling excited to see how they preform.