Bathroom Extractor Fan Bathroom 6 Inch Ø 150mm, Exhaust Fan with Backflow Flap, Powerful 200m³/h Airflow, Silent Ventilation Kitchen, Window Wall Glass Mounted for Shower Toilet Garage

Very smart look and easy to install.

Shut off flap a bit flimsy but works. Unit doesn’t fit flat to the ceiling, stands off about 5mm. Easy to wire in and fit. Extraction is effective and not noisy.

all good at this moment

Fitted the extraction fan and it is useless it says 20w when it’s only 15w its also is definitely not 150m3/h I removed the old one and that is only 96m3/h and this one is not half as powerful don’t buy

It's a plastic fan, It sucks air from the room, It makes a bit of noise but not too much

This fan moves a surprising amount of air. However, it does seem quite cheaply made (and by extension looks cheap) and the plastic frame is easily manipulated which can cause the fan blades to catch. Noise-wise, it's about on par with a standard bathroom fan. The majority of the "noise" is air flow rather than motor noise, which is good. There is a low hum, however.

Not much better than opening the window. Cheap and nasty. Cats' tongues are rough.

I didn't notice on the picture but the fan main plate do not have corners (circled). This meant, I found it difficult to align ithe fan with the screw holes from the previous fan. Also note, there are no electronics board, it connects strait to the live, neutral and earth directly. It is working fine at the moment, I will have to wait for the winter to see if it extracts the steam as well as the previous fan. When installing do not forget to remove the tape holding the flap (red arrow).

Useless

Der Ventilator ist relativ laut. Ich hatte vorher einen wesentlich günstigeren und der war merklich leiser. Die Rückstauklappe hält Gerüche aus dem Lüftungsschacht NICHT ab dafür klappert diese bereits bei leichtem Wind pausenlos und das relativ laut. Hätte ich das Kabel noch nicht gekürzt, wäre das Ding zurück gegangen.