SIM&NAT RGB 4 Pin Extension Weld Line, 4 Pin Female Connector Plug Wire with 4 Pin Male Connector for SMD 3528 5050 RGB Led Strip Light, Pack of 10 …

Great cable! I've bought RGB way better than the stuff I bought from my local store. The strands are decently thick and the insulating wire is good quality. I have digital LEDS so I didn't need wires just 3 so I just pulled one off like peeling a twizzler, if you eat twizzlers you know what I mean. Anyway the wire I didn't need was awesome for other connections and projects since I do a lot of Arduino DIY stuff.

So my wife wanted me to install lighting above the kitchen cabinets, the only problem was they are staggered which makes it almost impossible to do as you would need to hide the cable. Well this worked great, I was able to loosen the cabinet just enough to slide this behind and out of sight. Very nice to solder and I could not be happier.

The cabling works without issue though I do wish the wire in the center weren't so thin and flimsy. Still, that COULD be important to make the current carry properly and I can definitely say it's working well so no issues there.

I used these to wire some RGB light strips under my counters, mainly to make corners and get around a stove. They work just fine. I soldered all of my connections, I can't speak to their performance in crimp connectors. As you can see in the picture, their actual color order is GRB. My lights were set up like this as well, but word of warning if having the colors match up to the wire is really important to you.

The wire was very easy to work with - I cut sections and soldered the ends to LED lights in a long single strand to run all the lighting in my car

This wire is fine, but the gauge is VERY small... probably a 22. I'm using an Armacost LED tape light system, and needed about 6 feet of extension to get from one side of the sink to a cabinet on the other, and the voltage drop across that length prevented the small section of LEDs there from getting enough power. They came on, just not nearly enough to match the other lights in my kitchen. 22 gauge might work for other setups but not this one (where it otherwise should have been fine... within all other manufacturer specs for wattage, length, etc.).

Working with these wires is easy and seem a good quality

The "SIM&NAT 10M/32.81Ft RGB Led Strip Extension Cable Line for 3528 5050 RGB" I received was as described. It's 4, small gauge wires are great for extending an RGB LED light strip. The 1 issue I had and this is no fault of the wire itself was that the LED strip I bought was actually 5 leads because of its design.