idh by St. Simons 25411-019 Premium Quality Solid Brass Pocket Privacy Door Pull, Matte Black

1 hours install after cutting notch in pocket door and cutting a recess in casing for catch plate.

Good quality for sure. Easy to install if you are replacing an old one

Good quality. First, the specified cutout needs to be precise, very square and true to the surface of the door. The cutout creates the recess that the leading edge of the lock fits into the door. Also, need to drill out a hole in the back of the cutout for the locking mechanism to move. Use the same 15/16 bit and drill it about 1/2". Lock should move ok. Don't forget to loosen the two phillips screws. This allows the assembly to expand to fit your door. Then tighten when finished. The door must fit very flush with the jamb when closed. Otherwise lock will not catch in the latch plate. The latch plate requires careful positioning. Good luck but a very nice product after it is installed.

This is a really great product. Best latch for a pocket door that I’ve ever installed.

I replaced an old bronze lock with this one so it matches other hardware in my home. I had to adjust it to fit well and lock. It looks good!

Does the trick on a pocket door. Latches easily if properly aligned. Would buy again if installed another pocket door.

Finally got it installed by contractor. Latch closes but doesn’t open completely. The outside screw is loose and cannot be tightened. Too late for return.

Good quality for the price. Paid $11 CDN for it summer 2019. Purchased the oiled bronze finish model to match the existing house hardware and it's a good match.Only reason for not giving 5 stars is the instructions should have suggested pre-drilling the screw holes, as the screws are quite soft and subject to round out and scar the finish as I did with one you can see in the picture. Other than that, the instructions were easy to follow and installation was completed in about half an hour. I should mention the instructions we're a bit on the small font size. The height of the hole you have to cut is 2 & 1/4 inches and the depth is 1 & 3/4 of an inch.

Used in my bathroom reno pocket door. Just what I wanted

works perfectly

Very good

Chalet