304 Brushed Stainless Steel Sheet Gap Filler, Metal Trim Strip for Wall Oven/Microwave Combo/Range/Cooktop, Self-Adhesive Gap Cover, 30" Long, 1'' Wide, 20Ga Thickness

I used this to cover a space created when a new over-the-range microwave was installed. There was a gap of cut out drywall and tile in the wall right under my microwave. This strip adhered perfectly to the tile and looks like an extension of the microwave! So happy to find this!

With the installation of a new wall oven and microwave, we were left with a half inch gap between them. Nothing else could be done to alleviate the gap, so we took a chance at what seemed a bit spendy for a strip of stainless steel, and we could not be happier! It's of perfect thickness and length and strength, and the finish is SUPERB! We marked with pencil where exactly it had to go, and its adhesive backing locked it into place! There is just no way this could have been built better!

Great product. From the packaging it came in to the quality and application it was great. I was specifically looking for one that came with an adhesive and rounded edges, so this was perfect. The adhesive is strong and should last a long time. The only small downside was it’s quite reflective so it can be a little distracting when looking right at it. Overall, a great product and would recommend.

I used brand new Wiss metal snips to cut these and still had a difficult time getting a straight cut without bending the edge. I compensated for the flaws by placing the bad edges down and to the left. The left view is blocked by the wall. If you zoom in on the 2nd picture you can see the deformity in the strip. My recommendation would be to use some sort of table saw to make the cut. Other than this problem these strips worked great. The actual cutout for the oven is too large so the strips on the left and right are only 50% attached to the wood but they still bond well. They look great and other than the cutting issues were easy to install for a novice like me.

My wife wanted the stainless steel microwave lowered 2 inches so she could reach into it above the range. I put a 2 inch piece of wood under the front top of microwave and covered it with a 2 inch wide, 30 inch long strip. It matched the look of the microwave. Also lowered back bracket and found longer screws. Everyone told me it could not be done.

Had a built in oven and microwave installed that left a gap at the top. Was told a piece could be purchased online to fill in this 2+” gap for $399. Found this piece that stuck on to the surrounding cabinetry, took 1 minute to press on and no one would ever know the difference. Just make sure that you measure correctly.

Only one in a pack what a rip off

Works great, trimmed out the oven perfectly.