Sierra International 67023P Sterling Trim Gauge for Mariner/Mercury & Yamaha 2001, 2", Black

These are direct replacements and maintain your boat's original look. After 10 years, two gauges on my Chaparral started to behave erratically. So far I have replaced the oil pressure and the water temperature gauge. Both were easy to install, just remove the bracket from behind the dash, pull the gauge out of the dash, then disconnect the wires. Attach the wires to the new gauge, then reinstall. The new gauges worked great and read accurately. Tip: Be sure to make a diagram of the wires (or better yet, snap a picture) before you remove the wires to ensure the new gauge is wired correctly.

Solid, sharp and functional.

Good looking. Seems accurate. Easy install. Instructions could be clearer, but not much of a handicap if you have basic wiring knowledge.

Works just as expected and is still doing the job.Delivered on time and in perfect condition.

Looks Great.. How ever after using it for 1.2 hours, the tach states that I'm at 1500 RPM with the motor off and well beyond 7,000 at 3/4 throttle on a 2-stroke 85HP motor. The Hour meter has been flawless in the first 2 hours of use.

nice accurate tach, easy install directions include are stupid proof-yes you can-cutting the hole is the harder task. simple 3 wire hookup

purchase a whole set of the stering guages. I restored my 86 baja sport 220 the new guages & a 10 inch racing wheel give the old boat a great new look. also the guages worked well all summer.

This gauge has a silver face not white as shown

bon produit

Matches my other gauges perfectly. I now have an hour meter on my boat.

I was trying to match existing gauges in my boat's dash. 67364P was a very close match. The tach I received was a different part number and looks significantly different. I installed it anyway, works very well so far. In the end I suppose it looks fine as well.