Spurtar Battery Quick Connect 175A 4 Pack

great quality

This battery quick connect works great. I purchased a new ATV and wanted a hitch mount winch. I used this quick connect so that I can just unplug it when I want to remove it from the ATV. The connection is very solid, easy to connect and disconnect. It was easy to install on the winch wiring as well. I'm very pleased with this product.

Working great as a replacement connector on my BOSS snowplow

good way to save by making your own disconnects

Instead of disconnecting the post for either positive or negative, or both, it is easier to connect or disconnect the Spurtar Battery Quick Connect/Disconnect Wire Harness Plug,

Great product. Very high quality

Good product.

I did a search for "trolling motor quick disconnect" and came up with a bunch a things that would have worked, but weren't quite what I was looking for (these things!). A few days later I was searching for something else and these showed up in the "you might be interested in...:" block down below. I ordered 2 sets, as I was unsure how they would hook up, since I might want to move my trolling motor from front to back, etc. so I wanted to have both bow and stern covered. These things are exactly what I needed. I did not crimp them since I don't have a proper crimper and didn't want to just smash them in a vise. Another guy mentioned soldering the wire in with a propane torch (which I do have) so I went with that. I was done in less than 5 minutes, and some of that time was monkeying with other things. I just heated the connector in a vise, melted solder into the cup until almost full, then heated it again to make sure the solder was molten, and stuck the (10 ga.) wire in, held it steady until the solder solidified. Shove them into the grey connector, done! They click together solidly, and even have covers for when they are not in use. very happy with this purchase.

ROMMEL!!!!

Bra lev. Fungerar precis som jag har tänkt, mycket bra

Preformed exactly as intended.

Material is of Good quality. Note that the connectors are not for crimping with handheld crimping pliers, unless you already have tools for this kind of large connectors. They are prepared for soldering. If you have never assembled this kind of connectors before watch Youtube for instructions, since there is more than one way of making mistakes. It requires a certain amount of force to put the connectors into the house. The handles makes it way easier to part two connectors from each other because this kind of connectors are joined with force and that guarantees that they can handle the specified current of 50A.

Se ve de calidad