EternaBond EternaClean Spray Cleaner 14oz Can | EB-ECSPC | Prepares surfaces for Sealant Application by Releasing Contaminants like Oxidation, Grime, Oil and Grease, Tree Sap

Must with Eternabond Tape and it works great

Used product to clean area for putting down eternabond tape. Product cleans very well

I used this to remove some old EternaBond tape and prep for new tape. It worked really well. Was easy to use and easy to remove the old adhesive and filth. It is expensive, and a bottle doesn't go as far as you would think it would, but it works really well at removing the old tape and cleaning just about anything on your surface (tree sap, dirt, adhesives, etc).

It cleans as advertised. The instructions indicated spray 18" away. I did and a little ran over the edge of my trailer and took the paint off immediately! From then on, I sprayed it on a rag and wiped the area I wanted clean.I also think one could save some money and use lacquer thinner or nail polish remover. I glanced at the ingredients and I think is very similar. Smells similar as well.

Did the trick. I used the cleaner and primer then the tape to go over existing caulking. There was some leaking before but I haven't detected any since the application. My rv is small with little storage space but will keep a bit in the rv in case there are new surprises. The product was easy to use. I was working with an 8ft strip. Be sure to leave the vinyl on the sticky sided until positioned correctly or you may get tangled and taped yourself! I had a few issues where it was difficult to pull the protective vinyl away from the adhesive but all seems to have worked out. I used this to reseal the front and back end caps. The back required an overlapping strip to cover the thickness of the prior caulking. The ladder seemed a bit shaky at the roof and the caulking appeared to be cracking to I used the tape there and the ladder seems to be much more stable now.Thank you for

Works as described, easier to use than the stinky stuff in the cans. Minimal fuss and mess, just point and spray, wipe with a textured rag and you'll be amazed the grime that comes up. I used this to prep around a skylight opening on my aluminum roof and it works quickly with minimum odor. If you're going through all the trouble to make repairs just do it right the first time before you lay down your putty, sealant, eterna bond tape etc. I used this spray to also remove silicone residue and it worked great. Maybe I go the extra mile but also used a heat gun to 'burn off' any residue before laying down sealant tape putty etc.

Why did you pick this product vs others?:Save your money and just use some brake cleaner. Stuff smells and acts the same.Their conditioner is solid, though.

I highly recommend this. I tried scrubbing with only water and a stiff brush, and it was very time intensive to get through the brown dirty tinge that had accumulated on my rubber roof. I did the best I could with brush and water, and then wiped it dry and sprayed this Eternabond cleaner on and voila it was like magic to get the roughly textured rubber roof to look white as new. I could not have gotten it that white and clean with brush and water alone, for sure. After a thorough cleaning I cut a length of Eternabond repair tape to patch the hole in my roof and got excellent adhesion.