Benchmark AbrasivesTCT 6 1/2 Inch Circular Saw Blade, Tungsten Carbide Tipped Metal Cutting Saw Blades for Cutting Metal, Stainless Steel, Ferrous Metals, Miter Saw Blade (6-1/2" 48 Teeth)

Installed on my makita cordless small circular saw for cutting conduit and pipe. Have been running it for a few months and it is holding up very well. Blade stays sharp and fits well. Cuts fast.

Works great

Gets the job done. Got through a 3/4" diameter cold steel bar (not hollow pipe). Blade dulled, but teeth all survived.

I bought this blade to cut a piece of 20 AWG embossed stainless steel sheet to size, on my DeWalt table saw. The blade comes with a hole to fit a 1-inch arbor, but it comes with a spacer washer to fit a 5/8-inch arbor on the saw. It works more like an abrasive cut-off wheel than a saw. It forms a red-hot strip of kerf, so be sure to wear safety glasses. It did a fairly neat job, with a slight burr to the edge of the cut.

Worked good, didn't have any problems like other buyers had where teeth broke off or anything.

These blades work well until they start breaking apart. Very dangerous pieces come off at high speed.

What can I say, bought for a good price and works like it should. Using for cutting Legrand Wiremold 700 raceway. It provides a quick smooth cut.

i can't recommend these blades. i got maybe a few dozen cuts in 1.25 sch 40 pipe before it started shearing teeth off and fighting to get through the cut. as compared to the diablo blades that i usually buy i get typically hundreds of cuts before they start to show any signs of wear and then another few hundred before i have to push. not only that but they run much louder and show balance issues right out of the box whereas the diablo blades always run quiet and true. spend the extra 15 bucks on the freud blades.