DEWALT61147S 3300 PSI 2.4 GPM Gas Cold Water Pressure Washer

We purchased this for pressure washing our home and campers, but this could definitely be used in a commercial setting

Easy to assemble. Started on the 2nd pull. Works great. Would buy again.

Okay so I got my new power washer and had to assemble it. Not a big deal except the engine was mounted in the wrong holes on the frame. The frame is for a power washer with and without a starter. I ordered the one with the starter so I had to mount the battery box and battery. I soon found out the engine had to be moved so the battery box would fit. When I tried to remove the engine bolts I found out they were tightened to the point of nearly stripping and were stretched so I couldn’t reuse them. I replaced the bolts and remounted the engine and lo and behold the battery box fit. Then it came time to plug in the wires. Needless to say the wiring on the machine didn’t match the drawing in the instructions. There was an addendum to the wiring but it was wrong too. There needs to be better quality control at the factory so consumers have an easier time assembling their products.Now I will explain the pictures. The first is a side shot showing the stupid wiring that isn’t shown in the wiring diagram. The second is a shot of the bottom of the frame. If you will notice the gouging around the empty bolt holes, that was where the engine was mounted. The nuts actually gouged out metal on the frame because they were tightened to tight. The last picture is from the top. This shows a decal that shows the battery wiring.After all is said and done the pressure washer works as it should, plenty of pressure and starts easy. However the consumer shouldn’t have to fix the factory mistakes.

Excellent pressure washer. I’ve used several different brands and this is the best I’ve found.

Works great, easy to put together..

If you were to look in my shop you would see that I have been a long-time DeWalt user. Too many tools to mention here, but they have all served me well. But today is different. I have just received my DeWalt 61110S and I am TERRIBLY dissatisfied. I finished putting it together, added the oil that was sent in the box, added non-ethanol gas that I purchased only an hour before, connected my water hose and the spray hose, anticipating a good experience. This model has an electric start (2 bad rotator cuffs prevent pulling on a rotary cord). I then insured the gas was in the on position, moved the choke to crank, and hit the button. It fired up immediately to a low idle. I pulled the pressure wand trigger and started to wash the back of my truck and when I released the trigger, the unit cut off. So, I cranked it back up, and started again to wash my truck. The engine idles the same, under pressure or not. There is no increase in engine rpm. Once again, when I released the trigger, the unit cut off. It is sitting level all connections seem to be as they should bel.A sad note is that this model cost me twice as much as the Craftsman unit I still have. Brand new, and it is not, as Grandaddy used to say, 'Not worth kicking a hog in the butt for!'If there is a solution for this, and I find it, I will update this review. Until then, don't waste your money.UPDATE!!!!!!!At the risk of sounding like a complete imbecile, I am updating my review. The problem I had was that the engine would not rev. This was due to the fact that I assumed (We all know how dangerous that can be.) this engine was like my 4 previous washers, which had governors, rather than an adjustable throttle. And although I at first noticed the throttle, I did not exert much pressure to turn it. It is not too difficult to turn, but it is firm. So, in the long run, I give the unit 4 stars. The worst complaint I have with it now is that it is too low. I will be putting extensions on the handle.

Starts easily. Powerful cleaning. Works great.

Very powerful. Quiet. Versitile. Had some difficulty learning how to use it but customer service was great.