Chip Quik SMD/SMT Chip Removal Alloy (REMKIT)

Das Flussmittel ist nicht gut, das klebt wie Sau. Meiner Meinung nach nicht zu gebrauchen, das Lötzinn ist okay

Just what I needed and worked perfectly. I set my soldering iron station to 350 for easy removal of surface mount chips.

Great for quickly desoldering electrical components. Highly recommend

works like a charm

I went from toasted boards, burnt components, and peeled pads, to nearly (nearly!!) flawless component removal. With my iron set to 450f, the alloy tended to stiffen before it was fully removed, so I did bend two pins on the larger components (which were tiny, but larger than my initial tests). Maybe 500f would be sufficent for larger items? At any rate, it works miracles if you have a temperature controlled iron, allowing you to avoid unecessarily high temps. Flux the connections, melt the alloy on the iron and massage it in. In just a minute or two, the solder joints will soften and the components can be removed. You will need a lot of desoldering braid too, if you want to reuse the components, as it must be removed lest it spoil your solder joints moving forward. I highly recommend this kit and ChipQuik fluxes!