Garage Door Hardware Kit.tune up Kit

I was initially worried the wheels would be damanged with the super loose packaging (hinges were just thrown in a box wiht the wheels in a sealed back so everything was easy to move around during shipping/potentially chip a wheel)Otherwise, super easy to install:Mark the location of the old hinge, check to see if its number 1/2/3, remove the 4 bolts, slide the wheel out of the track... Assemble the new hinge/wheel/insert into track, replace 4 bolts, good to go. The process took about 20 minuteDO NOT LOOSEN THE BOTTOM WHEEL BRACKETS WITHOUT UNLOADING THE SPRING. Doing so will cause SERIOUS INJURY.TO replace the bottom wheel, open the garage door, bend the track open wiht pliers, pull the garage door down and pop it out of the track, and then remove the wheel to replace it. DO NOT LOOSEN ANY BOLTS ON THE BOTTOM BRACKET! The garage door will remain stable while doing htis, unless you have a loose or broken spring.Instructions are all over video tube sites

Super bright and easy to install

Great rollers. The hinges look sturdier than mine but pay attention to what you have. These hinges are all different and this kit does not come with top or bottom brackets. I didn’t realize that since it said kit. I needed more of a different number hinge than was provided. My fault. 4 stars because it seemed like this was all I needed. I should and done more research. The rollers are great and quiet!

Read carefully the list of contents as to the number of the various hinges and roller guides you need. The old ones have numbers on them - make sure you get the same number of matching hinges and rollers.Good value for the money. See utube for install hints. Work safe

My garage door is 30 years old and needed an overhaul. I’m very satisfied with the quality and ease of installing this kit but the replacement cables were too short for my door. However what needed replacing the most were the pulleys which I ordered separately from amazon. If you decide to replace the pulleys use extreme caution. Take as much tension off the springs as possible by opening the door as far as it will go before disconnecting the cables at the bottom of the door. If there’s still a lot of tension call a professional to do it. Also get some lithium grease and fully lubricate the cables. If they are frayed replace them. You might have to go to a hardware store to find the correct length.

high quality low price best thing I can say about a product. turned an unusable door into a nice quite push of a button. replaced old bent hinges and nasty rollers with your product and the result was night and day. along with the new cables that come with it the entire installation took about half hour.

Used 4 roll up door on a storage shed I built

I renovate old homes. Sometimes repairing a garage door makes sense. I removed the hardware from the old five panel wood door, stripped the panels repaired and repainted and reassembled. I ordered this kit for replacement hardware. The door doesn't come close to being able to be weather striped because the height or the roller brackets is too low. There are different height brackets available, apparently #1-#5. I had to purchase the correct height brackets from Home Depot basically doubling my cost. Also, the safety cable provided are too short to be useful for a stretch spring overhead door.