Eightwood Aluminum Enclosure Electronic Project Box DIY Black -2.95 x 2.75 x 0.94 inch (L*W*H)

This is a simple, well-enough made, and somewhat stylish upgrade over basic rectangular project boxes with a flat lid on top. End panels and screws fit fine, finish was good. It's aluminum and not, for $10 or so, mil-spec thick, so don't expect the end panels to be bend-proof (drilling holes, especially larger ones, resulted in very mild but correctable bending...just screwing them onto the body flattened them out again).

Excellent little enclosure! And it has slots in it for inserting a circuit board.

Plenty of measurements in the photos. I was able to build my project before the case arrived and it fit perfectly. The case is well made and sturdy. Standard PCB board fits the tracks inside the case.

Although Arduino Nano with the Terminal board was too thick to fit inside this case, I kept it for future use. Very nice finish and seems to be of high quality. It’s not too light nor too heavy. If your board fits, it would give your project a fantastic professional look.

Perfect size for Small sensitive electronic device.

It is what it is. Suited a small circuit in need of an enclosure

Works

This came with 4 screws that were ALL 1 size smaller and IMPOSSIBLE to use... I went to the hardware and found the right size screws for .60 usd each that fit properly. Good luck if you try to use their screws, have plyers ready to removed them with the head stripped and stuck 1/2 way end if you dont break them in the process. The rest of the box seemed well machined and well fitted.