Alpinetech 12mm 1/2" White 12V LED Metal Indicator Pilot Custom Dash Light Lamp

This was the solution to accidentally leaving the ignition key on for my UTV. Takes a 1/2" hole to mount, run a wire to the ignition key and to ground and that's it. The bright red light is easy to see in full sunlight.

Just installed this on my 77 kz 650 cafe racer for an oil pressure light. All of my gauges and indicator lights are deleted but I need to at least make sure oil is pumping. I was concerned about the length listed because it said 4" which wouldnt have worked due to the low clearance I have in the headlight bucket, FYI actual clearance needed is around an inch and a half. The only drawback to this light is it doesnt have leads and the posts were too small to land the factory wires so I had to make a jumper with 18 gauge, no biggie. The light is definetly bright and will I can definetly ser when it's on. In my case there is a little bleak through flicker when it's off but that is to be expected with 40+ year old wiring. I'm going to go ahead and purchase the green version for my neutral light. Hopefully they will last some time

Used this as a check engine light in an older car with a newer swapped motor. Works decent. I do have a glow from it when it is off, but I think a drain resistor should solve that. It is quite bright when it is on.

I used these in my jeep's custom dash. Very nice piece, little on the bright side at night, but a piece of window tint took care of that. Very durable.

Very good indicator light for the dashboard. I am using this one as a "PTO Indicator Light" on an old project truck. Be aware that the screws for the wire connections are VERY small, so unless you have a set of very fine phillips screwdrivers (like for electronics or eyeglasses) you will need to purchase one.

Just Excellent.

Everything about this light was good, except that the nut to hold it on the dash doesn't have the same threads as the light itself.So that makes it impossible to tighten it tight. I ordered a green and red one. The green light has the right nut and threads.

Works great. Not to bright not to dim