6in Wire Wheel Brush for Bench Grinder, Coarse Crimped Steel Wire 0.012" with 1/2" & 5/8" Arbor for Rust Removal - 1pack

Great deal and lasts long time. Fit my skill grinder great removes rust with ease. It don’t fling bristles much

Works great!

Product was shipped and received on time. The product's wire placement within the brush itself was not balanced, but had one spot where the wires were more dense affecting the balance. Perhaps I should have purchased the more expensive wire brush. But what I purchased will work.

These are a very aggressive high quality wheels

Space arbors were missing so now it’s basically useless because I can’t attach it my bench grinder.Update:Company contacted me and made it right. They sent me another wheel and the spacers this time. I would have been happy just getting the spacers. Works as advertised. I am satisfied.

Worked good.

I had four problems. The first was the rubber gasket? or the items used for the different mounting the wire buffing wheels on the motor shaft. The reason being that the large diameter circular plates used to hold the original buffing wheel tight on the shaft were designed with a small bevel to contact the wire wheel/and hold it did not work with the rubber adapters - my shaft was approc 5/8" or 3/4". Because the bevel shaft attchment washers allow the rubber adapter to slide on the shaft and not keep the wheel centered on the shaft. The fix was to find a couple of heavy/thick washers to use between the rubber inserts and the large 6" circular attachment plates. This has worked great with no problems for the past month. The second problem was the wire brush was not trimmed in a perfect circle. It was approx 3/16" out of round. Poor quality control. Not a major problem--but the wire wheel ia only touching the workpiece approx. 50%. The cure is to use the wheel for a few hours to wear the steel wires down on the high side. The 3rd problem was that the wheel was not balanced like the origional unit--no balancing holes were evident. Ane the 4th problem--safety note from the manufacturer-- wear safety goggles when using wire wheels.---during the first 30 seconds of use, the wheel lost 2 or 3 of the buffing wires--the wall insulation caught these instead of my face or goggles! A full face shield is the thing to invest a few bucks on!! That my story. A good price for 2 wire wheels--but the $26 dollar units might be the best bargin if you have to vist the Emergency Room!

It worked ok. I was trying to remove rust off of old metal lathe parts. The 6” wheel said 1/2” and 5/8”. No arbors came with it and it’s a good thing I had an old grinder sitting around with 1/2 spindle or I’d be sitting around today. Old Westinghouse adaptall motor 1750 rpm so balance and flying spears wasn’t a problem.I wanted something thing so I could get parts up in there. Had a nice bushy 8” but was too thick for some parts. This was cheap and did the job. Even though it did want I wanted it to do the fact it said it fit two different sizes means one size is a sloppy fit without an arbor and no arbor. 2 and a half but I rounded up because my parts are shiny clean.