4 pack

I think I've purchased 14 of these stainless steel cup holders over the last 2 years for various boats and they're all in perfect condition. They fit the standard hole size perfectly. If you’re creating a “standard hole size” you’re looking for a 3 and 5/8” hole saw. If you’re going to be drilling into fiberglass, here’s a few tips: 1. Put painters tape down over the are you’ll be cutting out. It’ll help keep the drill bit from wandering all over the place and scratching up that gelcoat you work so hard to keep clean. 2. If you’re using a standard hole saw bit for your drill, it’ll have the standard drill bit in the middle along with the big honking hole saw bit on the outside. Once you drill through the gelcoat with the center (smaller) drill bit, put the drill in reverse and let the drill back its way through the first layer of fiberglass before switching it back into forward to remove all the bulk of it. Running it in reverse first will lesson the chances of it cracking and spidering out everywhere. It’s typically a much cleaner cut. 3. Run the drill in low speed. You’re removing a bunch of material so don’t go heavy on it. You’re likely to overhead the bit and the saw will lose its temper (both literally and figuratively). These cup holders feature a nice drain hole on the bottom. When necessary, I ran clear tubing to a drain hose or to the deck and attached it with a stainless steel hose clamp, although I don’t think it would have come off just by the pressure it took to slide the hose over. If you got a size too small in the hose department, take a lighter or a heat gun and heat it up for a bit until it’s loose enough to stretch around the drain. Overall these things are an absolute steal and they enhance the look of any boat. Get ‘em while you still can at this price!

Solid quality. Perfect replacement for original drink holders on 22 ft pontoon boat. Nice upgrade. First purchased 4 for back of boat as trial and immediately order an additional 8 based of quality, looks and fit.

These sliped right in where the old plastic cup holders were. They look great.

Perfect fit for replacement….

Cheap stainless that will corrode if left out in the weather but if you cover your boat or store it indoors, you will be happy with them.

Nice cup holders. Use 3 5/8 hole saw for the install if needed.

Fit perfectly in my boat for replacements

Perfect fit a nice touch to the boat

Excelente producto muy contento con él

Buon prodotto

Exactly what you're hoping they are going to be. Well made, good quality and a nice weight. Just installed them so can't comment on longevity but they appear to be something that will last. If you're looking for a nice combination of quality and value, this is it.

Arrived early Nd in good order, quality, thank you.

Nous voulions changer nos porte-gobelets, car ils étaient en plastique imitant le métal et ont décolorés avec le temps. Nous les avons changer pour ceux-ci, en acier inoxydable. Nous avons un bateau ponté Princecraft et ils font parfaitement dans les ouvertures existantes. Notre bateau a l’air plus neuf et plus récent avec ce petit changement.