Amass 20 Pair XT60H Bullet Connector Plug Upgrated of XT60 Sheath Female & Male Gold Plated for RC Parts

My old Ender3 Pro power connector finally fried itself after over 5 years of use. This was an exact replacement and I know it's an authentic connector pair. Been using it a couple months now with no issues.

These connectors are great and fit together perfectly

Don't buy a generic. Buy Amass and you will be amazed how easy they are to solder.

Great and easy to solder

I hobby and build lots of different electronic stuff.My creations don't always look like perfection but most are 100% functional.This 72 volt "Frankinscooter" now can be charged with a single 36 volt battery charger. Sure these XT 60's look a little different but they hold up to heat and stay secure while riding around.With these affordable connectors my scraped together scooter can go an honest 50 mph. I can even beat Sir Ron Ebikes in my neighborhood!Thanks Amazon.

They are a really tight connection. I am very pleased with them. In soldering them, I first tinned the wire, but a little dab of flux and tinned the inside of the connector. Then I put the tinned wire into the connector and heated it all up. Watch out.....first time I did it I messed up the connector as I used too much heat for too long and the male connector slid out a bit. I tried to push it back in, but since I had plenty of extras I just made another one. Using them to connect motor legs to the motor controllers on the R2D2 I am building. Do not hesitate to buy these. They are quality connectors.

these things are great ... I put them on all my 12vdc radio equipment (and car battery power) and power supplies so everything is universal

The most important thing for me was that they can take the heat needed to solder them, which is especially important for the female connectors with their shallow solder cups. I've had other XT60 connectors that simply can't be soldered properly because the housing can't withstand the heat needed to melt solder fully into the connection. I can't stress enough how frustrating it can be to have a connector melt when doing ordinary soldering tasks - especially when I have 40+ years experience soldering and know my techniques are correct and the connector melts anyway.I took a chance on these, "Upgrated" (lol) connectors simply to test how well they hold up to a variety of scenarios. I tried to imagine what "Project Farm" would do, so I built a bunch of sets and checked for soldering heat resistance using a variety of heat settings on the soldering iron, terminal pull-out (ripping a conductor from the connector), crush resistance, and connection pull-out (pulling apart a mated set). In all cases, I was very happy with the results.If you don't have a decent soldering skills and some tools to hold things for you while soldering AND you don't have "classic" 60/40 lead/tin solder, you might have some trouble with the female connectors - they are tricky, no matter what, but I found that these connectors were trouble-free and I was able to get clean, tight connections without needing heat-shrink tubing over the connections. Make sure to SNAP the boot into place when you're done - you will likely need pliers to get the boot set properly.