100ml Large Plastic Syringe with 80cm (31.5in) Handy Plastic Tubing for Dispensing Injection

Very good got oil out of my engine but a little hard to pull probably because I’m old.

Did the job 🙌

better on thinner liquids. i.e water, brake fluid etc. ok on oils. does what you would expect. saves a lot of swearing very good for price. good service

Had my car back after a service with warning light saying to reduce engine oil level. I tried this, as I didn't want to wait. The supplied tube had not been cut level on both ends. At first, I tried the skewed end but it wouldn't go down the dipstick pipe further than 10 cm. Measured how much is needed using the dipstick and tried the other level cut end. It went in with no issues. As soon as I started using the supplied syringe oil started to travel up the tube. The trick is to pull then let it breathe for a bit. The initial air pocket will decrease. Kept at it until full. Had to repeat the same process seven times and was able to get 700ml out which was enough to get the dipstick to the correct level. Washed it with some soapy warm water and stored it in case this happens again ( so not really single use). The tube attached ok to the syringe and as long as you use it for suction you won't face any issues.

pipe width and length is good but the product build quality is poor and it's labelled as single use only. It works in a pinch and with some patience.

Came well packaged and on time. Tube was loose but easily fixed

Poor quality , no suction , pipe comes off easily. snapped in dipstick on engine. Do not buy.

As decribed and did the job i wanted it to well.