Dorman 949-006 Air Suspension Compressor Line Repair Kit Compatible with Select Cadillac / Chevrolet / GMC Models

Despite Amazon saying they don’t fit, I was able to install these on my 2007 GMC Yukon XL Denali with no issues. The line that goes from the pump to the passenger side of the vehicle was a little long but I just coiled it up and zip tied it out of the way. They plugged right into my air pump and shocks with no issues and no leaks.

Lines, Tees, and Elbows were tightly sealed. Fittings for shocks fit correctly with clips aligned with lands on shocks. I have seen other reviews that the line going to the driver's side rear shock was too short. I used this kit on a 2004 GMC Yukon XL Denali and the lines were appropriate length. I did not run the lines in the original OEM plastic wire loom. I purchased new loom and routed new air lines along OEM lines and tie-wrapped to the original routed lines. This assured an airtight system with new shocks, compressor and lines. I cannot comment on longevity as the lines have been recently installed. As of now, I am very pleased with the product.

Installed these to replace the factory lines on my 2008 chevy tahoe ltz. Easy install with no issues.

I wanted this kit because both ends of the line are terminated just like the factory OEM ones (mushroom head). The repair kits in the typical auto store have screw-on ends that are to be cut to size, which can be pulled out - but these ends allow for the better designed OEM fitting that cannot. However, the biggest concern before ordering was the fit/length. Even though this is not for my minivan (Uplander/Terraza/Montana/Relay), the hoses were long enough to work perfectly fine by routing one a little differently and the other with a circle loop to take up the slack.I didn't see anyone posting the measurements, so I will:* The longer black line/hose is 60"* The shorter black line/hose is 27"* The clear hose/line is 17".So this can be used with many, many different cars/trucks as long as the lengths are less than these!FYI: Be sure to use the clear line for the compressor connection only since the inner diameter is larger than the other two that go to the shocks. I replaced my shocks and couldn't get the old hoses out without damaging them, so all I needed were the two black ones - you may too.

Just exactly like the original components. Easy to install and will outlast the truck.

I'm not sure why Dorman states this is only for the '06 and earlier air-ride GM trucks/SUV's.Just installed it on my '07 Escalade EXT. Fits perfectly. Driver side is a little long but you can simply route it differently or stuff the excess in the air compressor housing. Passenger side reaches without issue. I didn't run the passenger side through the harness (most folks don't), but following the harness and zip tied to the outside of it.T is the same as the factory unit. Clear plastic how was also long; because I already installed a new Dorman compressor (and new shocks...it's been an expensive week) I just used the shorter clear hose the compressor came with but could have also used this longer one.No complaints; far cheaper than OEM and a much better solution as compared to the piece it together sets that have many more failure points, more work to install and cost more.Install is easy. All I needed was a few zip ties and needle nose pliers. Didn't even jack the truck up or remove the spare tire and my Escalade EXT is lowered (claimed 2/4 drop by previous owner...I think it is a little less).

Been trouble shooting for months as air was seeping from the new line...I thought it was the connector not mating well with the shocks. After carefully examining and comparing the original line to the new one, I discovered that the plastic line in the connector did not include two small o-rings like the original line. I removed the o-rings from the original line in install them on the new...like magic, no more air seepage.

Good product, no problems.Excellent seller and fastest delivery ever!I am really satisfied with everything!