OxGord15 inch Silver Snap-On Hubcaps with 9 Spoke Compatible with 2004-2006 Toyota Camry Standard Steel Wheel Covers

We Feel These are sturdy and fit Toyota Camry like OEM except for Logo. 15" = Go to your tires Look for "R15". There is a fit table and video on the site - use that to confirm. We bought these wheel covers Sold by: Fuel Rider for two different Camrys, a 2006 we bought new and a 2005, and were very pleased both times. We feel this set of four is a good value. Shipping was supposed to take a week but they came in two days.

After discovering that the hub caps I’d purchased a few years back had more than tripled in price, I purchased these as the aforementioned hub caps were on their last legs. These fit just fine, (though perhaps weren’t quite as flush to the wheel as the last set). Inflation is a bitch. These hub caps are fine but a little pricier than I’d hoped

My husband had a bit of trouble figuring how to get them on. Accidently cracked one in installation so we're ordering more as spares. We like the look hut wish they were metal.

No brainer. These are are winners. They are super easy to install, look great and inexpensive. I needed to replace one for my mom’s 2004 Toyota Camry. I couldn’t find the exact one but for 4 news ones, the price was unbelievable and I replaced all 4 and now her car looks fresh and new!

The metal retainer ring was hitting/pushing against valve stems on my 2006 Toyota Camry so hard I could not unscrew valve stem cap - I had to bend retainer ring out a bit and then wrap electrical tape around two retainer clips to make sure it was snug, I was then able to access valve stem to service for air. Retainer ring goes on facing DOWN -- when I put one on facing up, to try for more clearance to get to valve stem, retainer ring pushed so hard at bottom of valve stem at the rim it started leaking air! Super easy to just pop on in standard bend... if you don't check air pressure often. Real PITA to get it right on 2006 Camry.

Easy to install and look good.

Bought these for my 2006 Camry. Initially, I thought they didn't fit because they were loose and didn't snap onto the rim as they should. Then I found the tension wires that, apparently, I was supposed to install on each wheel cover. Really? Anyway, the wires turned out to be at the bottom of the box hidden under all 4 covers. Once I installed them, they fit snuggly. Other brands I've purchased have always had the tension wire factory installed, so it was kind of pathetic that they require the buyer to do it. It's not difficult, but I just wasn't expecting it. So, 1 star off for lazy manufacturing. Otherwise, they look nice and are a very good value for the $25 paid.

What with todays potholes this is a great option vs buying OEM hub caps that will only get knocked off sooner than later