Panel Paddle Valve Switch Dual Needle Gauge with Air Fittings for Air Suspension Dual Air Gauge Controller

Works great, so much easier than manually airing up my bags. Allows for on the fly adjustments and ability to monitor pressures.

The media could not be loaded. I installed load lifter Air bags on the front axle of my 2004 Winnebago Brave, 34D. I bought this air control system from Amazon and it was delivered in two days!Mounting was easy I had plenty of space below the dash and it came with mounting screws.I installed the compressor that I also purchased from Amazon in a baggage bay adjacent to the battery bay and ran a 12 volt supply wire from the switch that you see to the 12 volt positive wire of the compressor. The ground wire, 14 gauge to the negative pole of the house battery.I ran the supply voltage, 12 volts, from a point under the dash to one lug of the switch.Then lastly I ran a 20 foot piece of 1/4 inch air brake line from the compressor to the input on the back of the air gauge system.Now I flip the switch and the compressor comes on and I push the switch on the gauge up and the air bags are filled or down to release air. The beauty of this system is even though I don’t have the rear bags on yet, I can still raise or lower the air pressure in the front with the rear to be installed in the future when funds become available 🤠

I used this to control the front air bags in my motorhome. I wanted them to be controlled separately, left and right. Easy install, super clean product. Very happy with this purchase.

Muy bien

Overall worked well, I will say the switch’s are a little sloppy, sometimes it won’t go back to center and will leak a bit. But pay attention and you’re fine.

Didn’t last, lines pop off the switches and no way to really secure them again they just keep popping off. Tried to hose clamp then other one pops off and again and other one and again. Frustrating cause mounted and have to take off every time to try and fix again and again. Don’t know if it has warranty but good luck.

Product is not what is pictured on the site.. The T fittings are plastic instead of the metal showen on the site. The paddle valve are very sloppy in the bracket. I had the one posted on the site a few years ago. It was definitely better quality then the one they send you now

Strong build and clean finish. No leaks or issues