The Seat ShopDriver Bottom Replacement Seat Cover - Very Dark Pewter (Dark Gray) Leather (Compatible with 2003-2006 Chevrolet Silverado and GMC Sierra)

This was a spot on perfect match and replacement for for my 2004 Chevy Avalanche driver’s seat bottom. I had the dealer service do the install, which went in perfect, and they commented that it was an absolutely spot-on perfect color match, perfect fit, and identical quality to OEM seat replacements , which are no longer available. They asked where I found this, I told them - The Seat Shop in Texas, made in the USA! One month after install, I am so happy!!! Highly recommend!

Fits well. Be careful when cutting side panel for electric seat controls, it's easy to cut out more than needed.

Great fit and color match to original seat cover. Watch "the seat shop" videos on youtube for tips and instructions on installing. Call the seat shop with your VIN number to verify that you are getting the correct color.

Purchased replacement foam and a new bottom cover for my 2004 Suburban. Existing bottom foam was shot and leather was split. Watched and followed The Seat Shop videos on YouTube. Removed the seat and stripped it down only to find that the seat pan was cracked on the driver door side. Had a local welding shop repair the pan. Foam went back on perfectly. First impression of the leather cover was that there is no way it will fit back on. Rewatched the videos. Seat cover took some effort...brute force effort. Attached the rear clip then placed the seat bottom on the floor and kneeled over it pressing down hard to compress the foam. Finaly got the front clip to roll over onto the sheet metal and from there it went on pretty easy. Massaged out the wrinkles, reassembled, and it looks perfect. Two notes 1. Wear a pair of gloves. The sheet metal pan edges are sharp. 2. Watch the videos.I would certainly recommend The Seat Shop products for your GMC/Chevy seats.

remove from the truck to replace, you will have to do some pulling to get it to connect to holding brackets

This was a bit tricky to install, and you have to be careful cutting out the opening for the seat controls. Overall it is a very well made and high quality product. It looks much nicer than my old worn out seat did.

Fit my 2004 GMC Sierra 1500 like a glove, color matched great, but you will need to work on your Kung Fu grip to get the snap rails to engage. Otherwise, with a little patience it goes together just fine. Wife was blown away with the fit and finish and super stoked on new seat heaters from the seat shop boys.

I put this off for three years because I didn't want to mess with an upholstery problem , I replaced the seat heating element and decided to replace the leather also . Not difficult at all , just take your time and remember where everything bolts back together . And the videos helped too . Although I didn't replace the foam cushion because it was on backorder , I would recommend it if there is any doubt about the condition of yours ,it will make the leather fit like new again.