Rupse Fuel Sender Unit Boat Fuel Tank Sending Unit Fuel Water Level Sensor Stainless Steel Fuel Sender and Fuel Gauge for Boat Car Truck RV (6.8" (10mm Sensor Set)) (8.8" (10mm sensor set))

Quality seems good, have not installed yet but wired up on work bench to test. Seems to work well and will be fine for the zero-turn that I got it for, BUT it will go from E to 1/4, to1/2, to 3/4, then F. Not variable F to E. Checked sending unit with ohmmeter, and that's what it does. No gradual ramp up and down, just 5 outputs 240-141-105-66-33ohm.

Everything fit good , I put it on a rock crawler fuel tank

Was very easy to install. Like the way it's set up.

This worked really good after I realized that the float needs to bounce around a little to set the output correctly. It's snug being new and when I installed it it wouldn't read correctly until the fuel sloshed around enough to make the float rise to the correct level

Installed this on a Yamaha Golf Cart. Installed in about 2 hours. Easy job if you have some hole cutters and electrical experience.

Very easy to install. Hardware was stuck in the instructions so I had to open them. It's accurate and the ability to change the backlight color is pretty cool.

Wiring diagram was incomplete, had to make it up. Works now but difficult to wire.

Installation was easy other than understanding wire colors I like that it performs gauge sweep test every time it powers up and you can change back light colors is pretty cool!

Parfait

Purchased for boat fuel tank but hole pattern does not match my tank. Looking for return info.