Nargiboy YOEBI White Yoebi Wine Glass Holder - White

I purchased this to use on my pontoon boat with  Scotty 311 Drink Holder with Bulkhead Gunnel Mount and Rod Holder Post Mount - White . These are large cup holders and this wine glass holder fits perfectly inside. I use it with a Riedel Vinum Red wine glass and it holds the glass well. It is not super tight. I use it on a small, neighborhood lake and have had no issues, but with much wave action the device may not hold the wine glass tight enough. Of course, with waves the wine would slosh out of the glass, so I am not sure you would want to have it in a cup holder.I would note that the drink holder is too large to put in the cup holders provided in my Sun tracker pontoon boat. This is a large holder and you need a large cup holder to hold it. I particularly like that there are two areas on the holder that protrude out so you can position it in such a way that the stem is held in a particular orientation in case your cup holder is not perfectly level. I did not want the glass pushing on the point where you slide it into the holder, I wanted it sloped away from that point and that was easy to do.If you are able to have smooth cruising and have access to large cup holders, then this works fine. If it is choppy, then I think you have to stick with a beer (sorry).

It is a great idea. But, I found that it does not fit the drink holders, nor the drink holder cup holes in our boat. We tried it in about three different brand boats, all with the same results. It is to tight to go in the existing cup holders without using excessive force and likely breaking something. If you pull the existing cup holders out, it fits but is sloppy and likely would cause a spill. FYI, yours might be different, they are worth trying, but be prepared to return in case they do not work.

Although this holds a wine glass well, it requires you to remove your existing can holder to use the raw opening. I thought the product would insert into a can holder. That is not the case, it would not fit in standard can holders. The spring tabs that lock it in are very stiff and would make it impossible to remove if you can not access the underside (which is the case in our pontoon boat arm rests). Maybe it would fit directly into a wider container holder.

Bought a couple of these for the pontoon boat. Although they did not arrive when they were supposed to, I still give five stars because they work great. The fit very snugly into the existing cup holders and the hold your wine glass firmly in place. No more sliding wine glasses on the table when the boat starts rocking. Great product. I actually have four of them now.

The product has ribbed tabs on the inset portion of the glass holder designed to keep it in the cup holder tightly.My cup holders are stainless and the ribbed tabs on the glass holder do not grip on that stainless thereby allowing the glass holder to slip upward out of the stainless cup holder approximately 1/2".They still work and are a drastic improvement but just keep in mind that they do not seat tightly in stainless cup holders.

We purchased some home theater chairs and didn't feel like paying $50 a piece for the company's holders so we tried these and they are great. They are very large like others have said so be aware if you have more normal sized cup holders. Ours were so wide that a wine glass could tip over if that gives you an idea in size.

Great Idea, but doesn't fit all my cup holders. It is bigger then some of them, so it's tough to push it in. Others on my chairs, it just doesn't fit at all. So these are still good and will work, but I wouldn't say it's universal for every cup holder spot so be careful.

Didn't fit the cup holder... So I cut up the side and squeezed it in.

These had great potential, but they are a little too large to fit in the majority of cup holders. Only about an inch will fit into the holders. If they made them a little smaller, they would be wonderful.