Versachem4333092946 Muffler Tape Tigerpatch -3 Pack

I just put it in. Yes, it’s sticky, but not too adhesive. Little difficult to wrap around the exhaust depending where it is. I did use a part of a soda can to put over the hole. Might put a clamp on it.

I followed the directions on the back, it said to warm up the area before applying so I started my truck and let it run until the muffler was warm. Then it said for HOT areas, ie. Muffler, to put some aluminum foil on the area before applying the Tiger patch, so I used some aluminum foil tape. Applying the tiger patchs afterwards was easy, taking off the plastic is a littke tricky but if you use a knife to cut the plastic it will be easier to peal off. The plastic is on both sides. After wrapping the Tiger patches I used some more aluminum tape to help secure it down. Then the instructions say to run the vehicle for at least 20 minutes or go on a 20 minute drive. I let the car idle for 30 minutes and went on a 10 minute drive, so I think that was enough for it to get hot. I also drove it the next day and did thevsame thing. So far it looks like its done its job. No more noise escaping the muffler, the patches and aluminum tape have seemed to work.

Adhesión was poor quality.

Good value. Always good to have some on hand if you live in a rusty salty area. Shipping wasn't the greatest, items were thrown around and packing was damaged but product was still okay.

When I opened the packaging and taking off the paper back and plastic backing, I noticed it wasn't sticky at all. Not like what I read in the reviews from the product being so sticky people had suggested ousting it in the freezer to make it more manageable to work with. Followed the directions as stated. First try didn't work. Tried a second time and it seemed to have worked better than the first attempt. Let it cure, then went and ran my errands. Heard the rattle noise from where the break was at in my exhaust at the Y pipe. The tape didn't shrink up and adhere like it was supposed to. Instead everything I had wrapped had unraveled and cured up.

Worked well on my rotted flexpipe. Tricky to install, its been a week and holding on, well see how long it lasts.

This product is wonderful it works great but just Some of the reviews said it was too sticky to apply put it in the freezer for about 10 to 15 minutes maybe longer and you’ll have no problem using us but you must Heat up the metal but it shows in the instructions

Worked great for tiny holes i needed to cover.