Ventilateur de boitier Antec Prizm 140 RGB 14cm (Noir) 0-761345-77514-4

I purchased the 140 single and dual pack (3 fans) for my new build. Beautiful LED lighting effects work well with Asus Aura and the Z390-E board. At first, directions were tricky to figure out connections with the included hub. Once I figured out the chassis fan header on the motherboard, speed can be controlled via Asus Q-Fan via BIOS, and Aura can control LED patterns etc. You must connect the PWM LED cable to the hub and the ADD_HEADER 3-pin port just under the SATA ports on the mobo. To enable Aura control, sync the hub to Aura by pressing the hub MODE button for 5 sec.My only gripe is one of the fans has an annoying rattle, the rest of the system is very quiet. It's installed facing downward as an exhaust blowing upward. I'll have to exchange it for another one. The other two are smooth and quiet. I still recommend these, despite this minor issue. They should last a long time

Great fan. Would have worked fine, but I mistakenly ordered the wrong size. I still give it 5 stars because the 120mm fans I did eventually order were perfect for my build. I'm sure this fan would have been the same if it had been the right size. The mix up was my error and not Amazon or Antec.

Quite, quality build. Lightning is very good and response to my Gigabyte x570 board.

Good airflow and lighting, however, if mounted to an AIO radiator it will make a loud rattling sound. The sound will be especially loud if the radiator is mounted on the top of your case with the fans set to exhaust. I tested this with the stock AIO fans (NZXT), a pair of PCCooler fans, and these. These Antec fans were the only ones to make the sound. In short, good as regular case fans but not for an AIO.

This fan looks good and noise levels are also very good. It seems like it is well made and installed very quickly with the supplied screws and is controlled via the mobo on the chassis fan header and ARGB header for the lights.

The media could not be loaded.  After 2 years of ownership, the leds no longer work on their default color cycle. One led is stuck red, and multiple flicker, which none are supposed to flicker at all in the default color cycle.The fan still works well minus the led issues.

Beyond the cool looks, this provides great cooling, running air over my Radeon Vega64 video card.

These fans are awesome especially for the price. Many different effects. I plan on buying more.

I bought this to replace a CoolerMaster RGB fan which wouldn't run below 700 rpm using Asus Fan Xpert. This one runs at only 550 rpm minimum, which is enough to provide sufficient airflow at low loads, and is essentially silent below about 700. Above that you can hear the air noise as you would with any fan, but it's acceptable. I also like the black blades with only the outer ring being RGB, but that's entirely a matter of personal preference and others might prefer the fan itself to light up. RGB works fine with Asus Aura motherboard. You can buy cheaper fans but I've bought other Antec stuff and they seem to be decent quality so I am happy with this.

I bought the Antec Prizm 140mm fans for a new Ryzen build in an H510I case. As this was my first foray into the world of RGB I spent a bit of time reviewing the option out there. I settled on the Antec fan in part due to the specified performance which is comparable to other manufacturers, but mainly for the price point. When compared to other options out there which charge a premium the Antec fans looked very reasonably priced.The fitting was painless and worked flawlessly with AURA on my ASUS Strix ROG motherboard, attached to the ARGB header. After playing with the fan curve and finding the sweet spot between temperature and fan noise I couldn't be happier. Others mileage may vary depending on their usage and case.The build quality is great with build-in rubber padding at the mount points and the dual ring RGB lighting.Although I bought three fans I'm only using the RGB on one, this is in part due to the case which does have an open frontage and personal preference.Again, I couldn't be happier and I would recommend these fans for anyone who is looking for an ARGB option.

Fits well and mounting points are rubberised so no vibration noise. LEDs are very good and give a good case appearance.

This was a used item and the LEDs are burnt.

i cant say nothing bad about it for the money is briliant