Rayen24.2” x 8.5 Sleeve Ironing Board Cover | Elastic | Universal | Foam | 100% Cotton, White with Black Stripes

It was a little larger than my sleeve board but I could make it work. It's as advertised.

Liked the quality of the cover but it doesn’t fit as snuggly as I’d like.Since I haven’t seen any other covers for a sleeve ironing board this one will work.

Very nice and affordable replacement cover.

There weren't a lot of choices for replacing the pad on my sleeve board. This one does the job, but I think it is pricy. I thought it would come with more padding, but is is basically a cover. The box says it has 3 layers, but they are really thin. My board is a tad under 21 inches long and is 6 inches at its widest. It was a bit of a struggle to get it on; at first I thought is was not going to fit. The box says the dimensions are 24.2" x 8.5". But beware, it will not fit a board that large as there will not be enough fabric to cover the edges. There is no drawstring, just elastic. The fabric is OK. The box says it is "highly heat-resistant titanium resin". It is recommended that you install the cover from the wide end of the board forward and then iron the cover to perfect the fit. The product is made in Spain. I would prefer a plain cover rather than a print.

It fits well and holds up under the highest heat settings

Although they list the dimensions as 24.2" L x 8.5"W, they include the elastic edge, (that should wrap under the board to hold the cover in place), in those dimensions. And that elastic edge is a good 1/2" all the way around. So, this cover that should fit the sleeve board, is actually much smaller than listed. My sleeve board is 23" x 7-1/4" and this cover DOES NOT FIT. There is absolutely no way to get it on my board. Spent about 30 mins trying to force it, and the cover fabric has zero give to it. Very disappointed. I should have saved my money and sewn my own. Do not buy this cover unless you want to waste your money.

Good quality, good product

I have an old home-made sleeve ironing board, and until recently I was unable to find a new cover to replace the worn one. I was happy to receive the Rayen sleeve board cover, but it did not fit perfectly. I did not expect it to, and I used a large safety pin to tighten it.