Thermal Paste Silver Conductive Glue Paste, Conductive Silver Adhesives Paint Pen for Keyboard PCB Repair (0.7ml)

I used this to bridge the connection of the LCD for my PSP 1000 for the IPS display. I didn't have any issues using this. A quick tip is to cut off the tip of this slightly so it comes out straight. After doing this I applied to bridge my connection and I let it sit for 24 hours. I probably would have dried quicker but I wanted to be sure on this, after 24 Hrs. It was had to the touch and worked.

Used it to repair back glass defroster. The power tab had previously been repaired, and is solid - but after a year of use it no longer conducted 12v to the grid. I cleaned a contact area on grid and on tab, and applied the Silver Glue. As soon as it was applied I checked conductivity with an Ohm Meter, Success !!. Paste is thick and no runs, was easily able to lay a bead and it stayed in place. Temps are in the 50's, and the paste isn't 100% dry overnight. Figure best case, in a day or so it will harden. Worst case, it stays tacky, but don't think I'll have to worry about it liquifying and running off of the repair. Would buy this again, though it would be nice to have instructions written in English

I like the precision of the applicator. It works as it should. But the "ink" or "paste" makes this probably useless to you.I got this to help with some old xbox modifiications i like to do. These require bridging a very tiny section between two points. Conductive ink is the best way to accomplish this. But this ink has failed me each and every time.1. seems to spread as it sits which means it's going to end up bridging more connections that we don't want bridged.2. It does not seem to make a good connection no matter how it's applied. Even when i gob it and overdo it it still doesn't work. I got it to work once right away, but later in the day it spread and lost connection and now i can't seem to remake the connection properly. It's very frustrating.3. It dries and requires harsh scrubbing or even scratching with a hot soldering iron to remove. Very inductive Yu's sassss mmm guy

i bougth this thinking that will hold and be strong, but really what this is, its just paint.it will take a big amount of time to cure and will not be strong enough.

Does what it’s supposed to do.

Excelente para reparar microondas, lo recomiendo 100% cuando hay que reparar el flex

Llego rápido, todo bien

As recommended by other users, I repeatedly added small amounts of the paste, letting it dry for a day between each layer rather than trying to glob it on in one big application. I did not plan to rely solely on it to act as an adhesive, adding a layer of adhesive over the top of the junction to make sure it could not work loose and break the electrical connection. And yes, once dry it did form an electrical connection. It was used to connect a fine wire to a 24volt LED light board.