🔋 Connect with Confidence!
The X-Haibei Pair 175 amp 2 Gauge Battery Quick Connector is a robust and efficient solution for high-current applications. Designed for easy installation and long-term use, this connector features copper-plated silver terminals that prevent sparking, making it ideal for trailers, winches, and battery chargers. With a compact size and a complete set of connectors, it's the perfect addition to your toolkit.
| Manufacturer | X-Haibei |
| Brand | X-Haibei |
| Model | 1 Pair Battery Quick Connector Kit 175A 2AWG |
| Item Weight | 6.4 ounces |
| Product Dimensions | 3 x 2 x 0.75 inches |
| Country of Origin | China |
| Item model number | BT0098 |
| Is Discontinued By Manufacturer | No |
| Manufacturer Part Number | 175A 2AWG Connector |
| Lift Type | Automatic |
| Voltage | 600 Volts |
R**N
Great upgrade for snow plow cables
They might not be waterproof and/or indestructible, but they're certainly functional and very well built. There is a stout spring clip that applies plenty of clamping pressure for good conduction between the contacts. Mounting the cables into the plastic housing is a simple matter of slipping them in and hearing a click. It's almost impossible for anyone with normal mechanical ability to mess this up. Polarity is clearly marked on both sides so as long as you pay attention, you'll end up with a foolproof quick disconnect. Spray them with some dielectric lubricant to prevent corrosion and put them to work. I bought these to replace the pathetic stock connectors on a Boss snow plow.Note that crimping the lugs onto a wire really does require using a proper crimping tool. Don't smash it flat with a hammer or it won't fit into the plastic holder. If you are installing them on wire smaller than 2AWG, it will require a lot of crimping to get it down small enough for a good hold. It can be done, but it's not pretty.
J**K
As advertised
Worked great
W**.
Good product. Decent construct
Good product. Decent construct. Works.
C**Y
Quality
Would buy again
R**R
Ends
It was just what I needed
J**N
Works!
although this says it is for 2awg, it worked fine with my 4awg wire using the solder method. Just used a propane torch to melt a few big drops of solder into the metal connectors and then stuck the stripped wire ends into them. a tiny bit of the shielding melted but that wasn't an issue. I finished it off by putting some heat shrink on both + and - sides and then inserted the connectors into the plastic quick connect housing. No problems at all. Don't try to crimp these connectors. I tried and after a few smacks with a hammer using a hammer crimper, all it did was leave scuff marks lol. So the solder method is apparently the only way to make this work unless you're Thor.
K**Z
Quality construction, but will not fit WARN brand plug
Quality construction, but will not fit WARN brand plug.
R**T
Very convenient.
Be sure to buy a hydraulic crimper for attaching the ends to the wire.Be sure to get the right color since the different colors don't work with each other.
Trustpilot
2 days ago
2 months ago