Laptop 15 15.6 Skin Cover with Colorful Sun Rise Moon Fall Pattern for HP Dell Lenovo Apple Asus Acer Compaq - Fits 13.3" 14" 15.6" 16" (2 Wrist Pads Free)

I was a bit hesitant to buy this because of the mixed reviews. It arrived today and the packaging was great, but you could tell the post office bent it...which doesn't really matter since the item is malleable.It is a very thick skin and, while some people gave this one star because you can't restick it a ton of times...that is to be expected, especially after much use. However, I had to peel it back during application to thoroughly get the bubbles out and it was fine.Something important to note: One reviewer said that there were lines on the back to help guide you in cutting. I have a 13.3 inch laptop and the guiding lines are for a smaller device. I eyeballed it, which wasn't difficult. I didn't even need to use a ruler...but there are no guiding lines for a laptop my size or larger.Additionally, it is worth noting that the corners may need to be cut slightly if your laptop is curved. Not a huge deal. Just err on the side of caution and cut less. You can always cut more. I wanted my Core i5 sticker to show, so the wristpad sections look uneven, but that is deliberate.It is nice, thick, textured, durable material and I am very happy with it. You can tell that it is going to last a long time. I opted to put the design where it would be upright and front facing while looking at the back of the laptop. Personal preference.I have included pictures so everyone can see. I rely heavily on reviews when making purchases, so if my review helped you, I would really appreciate you marking so on Amazon.I try my best to leave reviews whenever possible so that I can contribute to the online shopping community.Enjoy!

What a lifesaver! I dropped my barely used laptop and scuffed it up pretty badly. I found this amazing product and am completely satisfied. My only hope is that it does not peel off with use because it looks amazing! In the future, whenever I get a new laptop, I will purchase this skin BEFORE the damage is done to protect it and add personal beauty. I did not cut the skin before attaching it to my laptop. I carefully smooth it over the entire top - smoothing out bubbles as I pressed it down. Very, very, very carefully, I trimmed the excess with an x-acto knife. It came out great. Don’t rush. Take your time and it’s an easy application. Probably took me 20mins total.

Ok, so the sticker is cute, yes. It's also very easy to install (if you do it the right way... I didn't do it the right way at first, and I'll get to that). It has a graph on the back to use to help you get everything straight, which was great for me because I can't draw or cut a straight line if my life depended on it. I was disappointed to see that the sticker comes as one big piece. I was under the impression that there would be the one big piece for the front and one piece for the keyboard area, but there wasn't, it's just a blown up picture of what you order (I order the purple lotus flower with black background). I guess you're supposed to use the leftover pieces of the sticker to use on your keyboard area? Well, for the picture I picked out, it's nothing but black leftover pieces, with a squiggly line here or there. The picture in the header shows a miniature picture of the same picture on the front, to use as the keyboard sticker, but this doesn't come with a miniature picture, it's just one big picture (not even one big picture and a small one off to the side. It's literally one big blown up picture), so be aware that you will not receive a second picture. Now for the installation part... there is a right way and a wrong way to do this ( I did it the wrong way the first time and it bugged me so bad I had to peel it off and do it the right way). So if you're a perfectionist like I am, you do not want a bunch of bubbles under the sticker, and if you just slap it on there and go, you will have a lot of bubbles underneath the sticker that are visible when any kind of light hits the sticker. When you put the sticker on, it's best to start from one side (top or bottom, left or right, it doesn't matter, just start from one side) and use a credit card, or anything that's flat and hard (side of a small box, side of remote control, or side of your cell... like I used) and hold press the one end down evenly, and use the credit card or whatever you're using, and to push the rest of the sticker down, pressing firmly (but not so hard you'll break the computer) and press down the sticker, piece by piece with the object you're using. Once u get the whole sticker down, start from the middle and use your flat object to firmly press again from center outward until you've got the whole sticker down and there are no mini bubbles, and then take your object and seal the edges really well, and voila, you have a bubble free good seal, and you shouldn't have to worry about any peeling. I however, have a little curl already going on one corner of my sticker, because I had to peel it off and put it back on because I didn't do it the right way the first time. I have had many of these stickers for my laptops, and each one has lasted me well over a year ( so I should've known better than to just slap it on there. I think the no keyboard sticker had my brain elsewhere, so I didn't pay as close attention as I usually do). I have a sticker from Mighty Skins on it's way (which is what I usually use because there's no cutting involved, it comes perfectly cut to the computer you're using, and has the keyboard sticker as well, and it covers the whole area, which gives a nice sharp look once it's all done), this sticker was cheaper and would arrive sooner, so I wanted to give it a try, but it wasn't even close to the look of what I'm used to, so I personally will not purchase for a laptop again. I would purchase for other things, but not my electronics. I like things to fit like a glove and look nice (not a big fan of the "you can tell I cut this and tried to fit it to my computer" look.

I am so disappointed with this product. It LOOKS nice, until you go to trim it and put it on your laptop. First off, the computer grid cut off on the back wasn't straight, it was crookee, so as i was cutting along the line, i wasn't cutting a straight line on the picture and had to trim even more free handed to even it out. It also just wont stay on. I only took once to put it on and I took my time, yet there are random spots that have bubbled up and it does not stick to the ends of the computer. Literally every single edge is peeling off. This was a Christmas present for my son and he was so excited about it, but we ended up having to just take it off because it wasn't staying on the edges. I honestly want my money back, but apparently can't get a refund unless I mail it back which is honestly not worth my time considering it couldn't even be resold to someone else. Don't buy it, it is not worth the trouble.

It's a great product. The delivery time was listed for around a month but it came in a week so very please.It's printed big enough to cover a 17.3 inch laptop easily. Fitting was a doddle. It has markings on the peel-off backing that make it easy to cut it to the right size. A good clean on the surface of the laptop and a little time attaching it bit by bit (I started left to right and peeled an inch backing at a time) and it sticks extremely well. The only downside is that because it's printed on canvas you can't get it to stretch around the corners if you have a bevelled edge to your laptop. I cut mine slightly smaller (see pic) and it looks amazing.The stickers for the mouse pad could do with being wider so that you can cut and fit to cover the whole resting plate but overall very happy with the product.

Great way of brightening up a laptop, mine was plain so got this to make it look better, it certainly stands out and looks great, also you get two smaller versions for below the keypad though I have only used one of them. It is easy to put on and easy to wipe clean with damp cloth so handy for keeping clean. Delivery is a bit slow but other than that it is not a problem but it is worth the wait.

According to the picture it fits edge to edge. My laptop is a Lenova G50 15.6". Description says it will fit. It doesnt. Picture shows. Looks silly.I know the description also did give the measurement, but when you are after a Lenova 15.6" skin and description says will also fit a 16" - stood to reason it would actually be to large for mine if it fitted a 16" .... Anyway, its there for now until I find another one, then its coming off and in the bin.

This cover is simply not wide enough to cover a 15.6 laptop from edge to edge. It's short by about 1/3 inch. One of the two smaller stickers, designed to fit around your touchpad is a good few inches too short to cover the area from the pad to the edge of the laptop.However, the quality of the cover seems quite good and I would probably give it 5 stars if it was wide enough. So although I cannot recommend this for any laptop larger than 13-14", on smaller laptops it will fit perfectly (though again don't expect much from the two smaller stickers)Finally, the name of the seller is a bit misleading as this is shipped from the US, so don't expect a fast delivery.

the first one of these that I bought was gorgeous, great quality, and a lovely picture. However, I had to remove that one to send the laptop off for some repairs, and didn't store it correctly, so had to buy a replacement. The second skin is much blurrier - the print quality is not so great and the colours are not particularly good. I think it's a bit of a gamble with this product - if you're lucky enough to get a good quality copy, you'll love it, but if not it's quite disappointing.