Hobie Kayak Anchor Trolley kit Universal # 72020073

I installed this on a Hobie PA 12 and it could not have been easier to do. Works like a charm. The only negative is that when using the H-bar tackle box or the H-bar rod holders they interfere with the ability to have the eyelets move freely along the side of the boat. To address this I merely position my tackle box forward enough that I can reach the eyelets to clip on my anchor and then rotate toward the back of the kayak so I can cast forward. Seems to work well for that. I also use this in conjunction with the Yakattack sidewinder to help determine how much slack to allow in my anchor line. Seems to compliment the trolley system well. Would recommend and again if you have a PA12 or 14 this is a breeze to install since the have predrilled brass fittings on the hull already to attach it to.

This couldn’t have been easier to install on my Hobie PA14 360 kayak. Popped the four screw covers off the kayak and installed the guides very easy. I did have to trim the rope on it as this is a universal trolley kit but, that was super easy as well. Just trimmed what I didn’t need and tied it back onto the bungee cords and works like a champ!

I didn’t use it on a Hobie kayak but it worked perfectly and installed quickly.

I think it is a bit overpriced but it is by far the easiest anchor trolley I have ever installed. There were parts left over when installed because this is a universal kit and most of the work is already done on the PA series kayaks.

Didn't come with proper screw length for the pulleys..... hobie pa 14 360.. Came with three1.75", two 1.5, and one 1.25.. (If i remember correctly).. Had to go to home depot to get some 1" and 3/4".. Everthing else line up good..