RJ45 Cat6 Pass Through Connectors Pack of 100 | Clear Ethernet Plugs for Unshielded Twisted Pair Solid Wire & Standard Cables | Compatible with PC, Server, Router

REVISION: The initial poor review (below) was 100% due to my error. The connectors DO work well. The pass-through design is WONDERFUL. My error: I got lazy building Cat 5 cables and didn't always bother with the 'crossover protocol' and simply went with pairs of matching color wires on both ends of the cable. THAT DOES NOT WORK WITH CAT 6 WIRE as I discovered after wasting a few hours thinking it was me, my crimps, the plug design, etc. In short, be sure to follow the recommended wire color order (which involves a 'cross over' of the blue and green wires). I finally did as I should have done all along, and voila! We have excellent connectivity. -------------- INITIAL REVIEW FOLLOWS ---------- These plugs made it impossible to get a good connection when plugged in to the router/switch/pc on one end, and the other devices (cameras) on the other end. We built 6 cables (12 - 14 ends) for a camera system. Not one cable successfully brought the camera online. We cut off a few ends in case it was my fab error. It was not.

Easy to use

Works as advertised and much less expensive than comparables.

Bought these for our department. They are pass through so it makes it easy to see if all the wires are lined up before crimping. They arrived on time and work as intended.

Good purchase, good product, will buy again.

These are awesome. You can easily see the wires are inserted correctly and then slice the excess off. Make sure to have a precision cutter (exacto knife, precision diagnal cutters, razor blade). you have to make sure the excess is cut as close as possible so when the end is plugged in it will go in far enough to lock.

These connectors are terrific, I wish I found them sooner. The ability to pass-thru the wires insures a perfect connection each and every time. Had a few connections to do and these connectors made it a breeze. Make sure you have a good crimping tool to ensure the connectors pierce each wire.

Works perfectly with cheap CAT5E. I am consistantly getting good test results from cables built with these connectors.

This is the only RJ45 plug I have found with poles large enough to pass through an individual Nexans Cat6 wire. The problem is that the diameter of the insulation on each wire is too wide for the plug when trying to terminate (crimp) all 8 wires side by side. So, pole 1 is fine, but pole 2 overruns onto pole 3, meaning pole 3 will not pass through because it has been nudged over to pole 4. Even if you strip back the insulation and pass only the conductor through, the conductor floats across the poles because there is nothing to hold it in place when trying to secure each wire into its assigned channel / slot. To be fair, I may be the only person trying to terminate Nexans Cat6 onto this type of plug (POE CCTV direct to an external camera), and I accept that RJ45 is a universal standard so it either works or it doesn't, but given the problems I have had with other so-called Cat6 plugs, I am not so sure.

My cat6 cable doesn’t fit in these things so beware

Los conectores pass trough facilitan mucho el trabajo y es difícil encontrarlos en Cat 5e

Good one this connecters

It works well and very easy