AYAO72-Inch Band Saw Blade X 1/8-Inch X 12TPI to Fit 10" Delta 28-140, 10" Wen Band Saw and 11" Shopsmith, 2 Pack

I got these as substitutes for a Starrett blade of the same dimensions (1/8", 14 TPI); despite the identical tooth count, these have a more aggressive cut that leaves a rougher finish than that of the Starrett blade. I eventually went back to the Starrett for the finer work that I usually do with this size blade, and will save these for stuff where the finish isn't as important. That said, they are half the price of the Starrett blade, so they're a pretty good value over all.

This blade didn’t work for me at all. Bought it a year ago, but just now had a need to open it up and use it. Right out of the package, it cut (if you can call it that) as if it were dull. I thoroughly cleaned it — getting off any chemicals that it may have on it for preservation — but still had the same result. I have to really push and go slow, plus it burns the wood and gets so much resin on it, I have to clean it — and the bearings — after 1” of cutting. I’ve even tried lubing the blade with wax, Bioshield, etc. Will never buy this brand again.

Haven't used this a whole lot yet so I'm not sure how durable it is, but it cut fairly easily and made some nice curves. If it lasts even close to an acceptable length of time I will continue to buy these blades because hey, two blades for a little more than the price of one at a specialty shop.

Blade perfectly fits my Shopsmith band saw. I haven't cut a lot with it yet, but it runs smoothly, no jumping at the weld. It seems to cut fast and smoothly. I generally only use a 1/8" for scroll cutting pine or softwoods less than 1/2" thick and it seems to work good for this. May not be as good as the Shopsmith blades, but for way less than half the price is a real value.

Works great. With proper blade tension and guide blocks does not drift and is very sharp.

Quick delivery and put it to work. Cut hard wood like butter

Works very well.

After reading through the remarks I agree the Wen 10' saw doe's not track a 1/8 blade! I cannot say it's the blades fault but that is why I gave it a low mark!