Xiaoyztan 0.5" Supporting Height Adhesive Insulated Standoffs Sticky Reverse Mount PCB Spacer Fit for 4mm/0.157" Hole, Pack of 30Pcs

Buen adesivo

simpler and faster than 3d printing new mounting plate

Great for ATX mother boards. I dont use the sticky area, so for me it is the right product for my needs.

Fantastic standoff and my go to for NEMA enclosure standoffs. They are well made and the adhesive is sufficient. I do add a drop of super glue to them because of the varied temperatures of my installs.

I mounted Dell (non standard) E-ATX board in Mattrex 55 case and wanted to fill in some of the holes that have no corresponding standoff for case. However, these standoffs/spacer were wrong size. I think these might work for mounting a board outside of a traditional case but apparently newer cases call for m3 standoff (according to ebay). No search around the internet gives you the exact size for a normal newer case. I measured it myself to be 6 mm for the standoff that came with case. I am guessing this is the standard used these days for most cases. Its really difficult to measure these standoffs unless you use straight edge with ruler. I got about 8 mm, so 2 mm difference is way too much to use with my case explaining why board was flexing so much.

I needed these standoffs for some circuit boards - they fit perfectly for a #6 screw! Huge win!

Work grate thanks

The stock must be very very old. So old that the adhesive pads lost their adhesion and is no longer sticky. I tried about 6 of them, all had the same issue of lack of adhesion. For the cost it's not worth returning. I suggest look elsewhere for a vendor with higher volume which would indicate inventory turnover.