RULLINE 2 inch Hardware Exhaust Clamp, Lap Joint+Bolts Band Flanges Clamp Stainless Steel Universal Compatible with Muffler Downpipe Catback Pipe Connector

Good bang you the buck I can't hear my truck wish you luck

Still working great . Easy install

It’s a lot cleaner looking than the clamps i had previously and decent for the price but, even though the listing says its a 2 inch diameter sleeve, it is, but the supplied hardware is not the correct length to properly clamp together. In my honest opinion, I would only recommend this if you are the type of person to keep spare nuts, bolts and such, just incase you buy something like this as i had to use a longer set of bolts as again, the supplied ones are inadequate size.

2.0 Inch Exhaust Clamp, Band Clamp LPFIDI 2" Exhaust Clamp Pipe Joint Bolts Band Flanges Clamp Walker 36534 Exhaust Clamp for Chevrolet Cruze - Walker catalog says this is a 50mm clamp, not specific to Cruze RULLINE 2 inch Hardware Exhaust Clamp Universal Exhaust Clamp Pipe Connector Double Clamp Ø 50 x 125 mm Warning. The spec for all these 2.0" and 50mm double band clamps are for 2" OD pipes. They will not accept pipes bigger than 2" OD. We tried all of them for 2" ID pipes, which measures slightly less than 2 1/8" OD. The band clamps will not fit. At their widest loosed position, they are meant for maximum 2" OD pipes. You can get away with 1 7/8" ID, but that is about it. These bands clamp from a max 2" OD to roughly 1.5"/1.6" OD.

Very good quality. This clamp did fit better than the one I received with an OEA exhaust system. Just make sure you have the right measurement, and it'll slide right on. I will say the materials used were pretty good as well as they didn't rust as the piece I received with the exhaust system was rusting quickly.

Wow! This was better than the other clamp I used earlier. The other one that I used slipped off after a few weeks because the two pipes had a 1/16 or 1/8” difference in diameter. The replacement muffler had a 2” diameter but the original exhaust pipe was a tiny bit smaller! This clamp is longer in length by an extra 3/4” so that was good. There was a 1/2“ or so of a gap between the pipes (it was a poor estimation cut on my part). But to make sure the clamp doesn’t move I’ve installed hose clamps between the clamp for reinforcement. This was way easier to install because I didn’t have to manually compress the clamp. The other clamp needed 3 hands to install. Anyways, it cost a few bucks more but after my experience with the previous clamp, it was well worth it!!! Highly recommended.

I used this to fix someone else's work. Fast and good.

Both bolts stripped right away. I tightened by hand with a 3/8" ratchet. I was using half the handle and not that much pressure. Unusable.