ATV/UTV SXS Turn Signal DIY Street Legal Kit (No Wire, Round LED)

Fit my RZR 900 trail perfect, easy to install and works perfectly.

Put on my utv. Works great

The kit is fairly easy to install just make sure you have enough wiring to run front to back. Recommend running a second ground wire.

Spent a lot of time troubleshooting this kit. The LEDs would glow very faintly but not light up. Occasionally I would hear the relay click and one of the LEDs would go full brightness for a second. Thought I had bad grounds or something but when wired directly to 12V, the LEDs lit up just fine and stayed lit. Went to auto parts store and picked up another 12V low-power digital relay made for LEDs, then everything worked fine. Update: I spoke with Advance MCS Customer Service and they are sending replacement parts. Sometime a bad part comes along, and it's not their fault. They're making it right.

The kit was good and the directions were good. This kit came with more lights which makes it much better kit than the previous 7 kits I purchase for other machines. It even has white lights and miniature LED lights for under dash accents. Great kit at a great price.

I used this kit to make a 2014 polaris sportsman 850 street legal. I mounted the rear lights inside the rear taillight housing by drilling out the blanks, and the fronts on the grill. The led lights I recieved were usable, but found out halfway through the installation that some of the lights were wired backwards than others. I spent an hour trying to figure out why some of my lights didn't work. The toggle switch is junk, but I bought a universal blinker and horn switch so I didn't plan on using it anyways. Led's are bright once they are wired right, and the relay and horn are usable. I'm not sure if I would buy again, but they worked.

Not too easy to install

I liked this kit that came with everything minus wire. I knew that coming in. The instructions were nice but could of used black is positive and white is negative on the leds but lucky I ready some reviews that said that so I didn’t have to find out on my own. Got it all install and tested and 1 Red LED doesn’t work. Emailed the company about a week ago, still haven’t heard anything. I will change my review to 5 stars if they replace the bad out of box part.

I have done a fair bit of auto electric wiring in recent years so I purchased the kit without wires. It came with a few connectors and some zip ties, which I didn't need or use. The LEDS are good and bright. I had some concerns that they may not be very visible due to their size, but that was not the case, they look great. The rubber gaskets around the lights make for a very clean install. While the ATV is running, I can't hear the blinker at all, so it's nice that the two tiny indicators were included. I mounted them in a way that I'd see them clearly and not drive for ages with my turn signal on without knowing. I'd buy this again if I needed another kit and I'd recommend it to others. The only improvement I'd want is a nicer rocker switch as opposed to the toggle switch that comes with the kit. The toggle switch works fine, but I prefer the aesthetics of a lower rocker switch.

Le kit est conforme à ce qui est mentionné et aux image et plan d'installation est clair et visuel si on a un minimum de connaissance en électricité. Peut-être un peu dispendieux, merci!