SINGARO Car Rear Bumper Protector, 42inch x3.4inch Car/SUV Universal Rubber Anti-Scratch Trunk Exterior Accessories

This was a great fit for my 2025 Subaru Forester...once I trimmed it. The product is well made, thick, and of a nice quality. It doesn't come with installation instructions, which I think it should, but was easy enough to figure out. Just make sure your bumper is very clean and dry before applying. I used some rubbing alcohol to prep the area. It was fine on the length, but the width was a little too large for my vehicle. It's very easy to trim along the guidelines with sharp scissors. I chose to trim off one section on the edge that was on the exterior side of the bumper (as it would be the shorter side of the length). The nice thing is that the plastic liner peels off in 4 sections, which makes it easier to apply. After locating the center of the bumper, I aligned the product on the bumper matching center to center. I then used some painter's tape to hold down the left side so that it wouldn't move during installation. Then I removed the liner from the center right side and slowly applied the mat to the bumper from the center towards the right and then repeated with the next section of liner on the outer right section. The process of taping down the left half while applying the right half allowed for no movement during installation of the right side. I then removed the left side of the liner in the same order as the right and smoothed it down with a towel to remove any possible bubbles. It was a perfect installation.

My Crosstrek bumper already had a couple of scuffs after a month, so I decided to give this a try. It was easy to install and the fit was great on the Crosstrek. Looks pretty good and no trimming needed. I installed it on a day that was about 40F, and it adhered well. It has since held up through freezing temperatures. There hasn't been any hot days yet to evaluate heat tolerance sin I installed it, but I will update if there are any issues..

Great protector for a Great price, easy to install, and great protection. No triming needed for 2026 crosstrek

Good quality, not a perfect fit for my escape. Universal maybe, but not ideal for all.

Easy to install you can cut it to fit width size.

Worked great on my dogmobile bumper. Pieced 2 together to cover the full length. Holding well for 2 months now with my 90lb GSD jumping in and out on the daily. 👍

It comes somewhat larger than needed, but it's easy enough to cut. Just be careful that you get nice, clean cuts, or it'll look pretty bad with ragged edges. It's a good non-slip surface, and the adhesive backing is great as long as you get a good, clean surface to adhere it to. It should provide some good protection to my bumper, and it looks pretty neat. It comes rolled up tightly, so you'll probably want to lay it out flat for a while to make it easier to work with.

Just put it on today. It fits well, easy to install, i wish it were a little wider to cover more of the trunk.