Complete Electrics Wiring Harness Relay Stator Coil CDI Solenoid Spark Plug for 4 Wheelers Stroke ATV （50cc 70cc 110cc 125cc） Pit Quad Dirt Bike Go Kart taotao by OTOHANS AUTOMOTIVE

The kit worked perfectly for my needs. I used it on a 100cc four wheeler.

Great deal replace total electrics for under $40 no issues was easy to install

Great product, at a great price. Lengthen the starter wire, please? Otherwise an awesome product. Thanks again...

Out of the 9 pieces only 5 are the same and will work with my taotao 110cc wheeler. The spark plug, Key switch, cdi box, voltage regulator and starter relay are the same. But the rest of the parts won't work on mine. The stator, handle bar switch, wiring harness and coil are completely different. Now I have a 2015 and a 2021 and everything is the same on the 2 quads except the handle bar switch but the one that comes in the kit won't work on either.... I needed the stator for my no spark issue so I will need to buy that separate now. Changed to 1 star. So the regulator that's in this allows the motor to over charge the battery. Will go up to 17 volts and starts messing with the quad running..... so what few things that come in this kit that do fit are junk!

completely rewired my atv and it works great

This harness is way to short from front to back for my Tao tao 125D so did the best I could to make it work. Tested before zip tying everything in place and worked, zip tied up and that is when the fun started. Engine ran very rough then would rev full tilt until I turned the key off. The kill switch didn't work, then the start button wouldn't work, then nothing worked. Each problem was a pin connector not crimped to wire so I soldered them in place. then thinking all was well tested the engine again and was running but not well so tried setting the idle and all of a sudden it revd super high so I turned of the key. Tried a few minutes later and nothing worked. I took everything apart again and that's when I found what's in the picture. So the kill switch, start button and ground connectors so far. I have several hours working on this and all I can say is you get what you pay for.

this is a generic harness for the chinese mini quads. The plug in terminals did not match the ones on my quad nor did the wiring colors match. You will spend days even if you are extremely mechanical cutting soldering and trying to figure out where every thing goes. All I needed was the stater and pulse sensor but the wiring did not match what I had even though the stater was identical. good luck

Exactly like the picture! Works perfect had to switch an end to fit our Eton impulse 50 but it's a universal replacement and did it'd job!