Acrylic Display Stand for Lego Dune Atreides Royal Ornithopter 10327- Wall-mounted Display Holder for Dune Inspired Model (Stand Only, No Model)

Note: I have the brackets upside down on in the photo; I fixed them before mounting.Naocard’s acrylic wall mount for the Lego Dune Ornithopter is pretty good. It is sturdy and should last a good long while.The mount works well enough. You only have to remove two telephones from the skids to place the aircraft, then run two long x pins through the frame. After a lot of struggle, I just couldn’t get the upper one through. The lower one seems to be sufficient.I don’t trust the included adhesive wall plate. It might work fine, but I have zero desire to have this thing hit the ground so I used two screws into a stud to hold it.The wonky thing is the wing brackets. There are 8 block-u shaped acrylic bits that force the wings into a fully outstretched position. They work, but add a bit of lateral stress to the spars. They are noticeable up close but not from a distance.So it all works albeit in a kinda clumsy fashion.Made in China.

Completely useless - tried to mount this, Per directions, and one pair of holes are out of alignment completely. I have my doubts about the "Wall Adhesive Plate" as well; I didn't mount that part either. It comes with "C clips" for the wing pivots, but don't hold anything - they're TOO big and fall off.