12V Cigarette Lighter Socket, 2 Pack Car Marine Motorcycle ATV RV Lighter Power Outlet Socket Replacement 12 Volt Waterproof Plug by ZHSMS

Works Great. Good Quality . Thanks

Perfect fit, easy to install, and works as expected.

Installed at stern of boat to plug pump and other things into. Works great

I ordered several of these and installed them on my boat several months ago. I live aboard with my wife, so they've seen a lot of use in that time. I'm overall pleased with the quality of the sockets themselves. They install easily, with male spade terminals hard-mounted on the back of them for easy connection to the wiring harness.The good:* Sockets work at both 12v and 24v DC (they're not rated for 24v but I haven't seen any issues)* Sockets are standard diameter and depth so they don't have any issue fitting in as replacements for older onesThe bad:* They're listed as for marine use and the sockets themselves seem fit for purpose, but the wiring that comes with is anemic (undersized), not marine wire (fully tinned strands), and the terminations are weak and sometimes easily pulled off* The inline fuse may or may not work but I've had two of the fuse holders melt until one of the wires separated (which should never happen) while passing less power than the fuse was rated for.Bottom line: the sockets are great and worth the cost but throw away the included wiring before you're tempted to use it. It's not an exaggeration to call it a fire hazard and it gives you a false sense of protection. Fortunately, all of mine are installed after 5 or 10a breakers, so the fuses are redundant and I would've been protected from a short resulting from the failure I mentioned. I've since replaced all of the wiring with more appropriately sized and properly terminated Ancor wire and terminals.

Easy to install and it’s a good upgrade from the boring stock ones.

Comes with everything you need to make a 12v connector. Recommended.

These sockets have an Inner diameter that is too large for my device plugs... they fit too loosely & eventually vibrate out & disconnect from the power... I have to shim the I.D. with thin sheet metal to hold the plugs in securely. The other sockets from this seller that have the outer plastic threaded mounting part going only half way down is much better made, has the correct size I.D. & holds plugs very securely, but is not fully enclosed in plastic at the bottom end. I chose the "loose" ones because I am mounting in the fender of my ATV & needed one fully enclosed to keep mud, water & dirt out.

Used for a battery box build. They work fine but they’re long so make sure you have the clearance behind it. The weather cover is thick and makes a good seal. The threaded ring on the back is plastic as are the threads on the outlet. Over tighten it and it will skip a thread. I used a drop of glue on the back to hold the retaining ring in place.

Bought these to fit in my 2016 Ford Fiesta. I purchased the top spec model of the Fiesta but for some reason Ford decided not to include a boot and rear passenger 12v socket despite including a place for them in the plastic interior panels. These were just plugged with covers from the factory but the wiring was in place behind the cap. These sockets were the perfect solution and only took me about 15 minutes to pop the caps, splice the wires in and screw the sockets in place. Quality is good, but the locking rings are bit fiddly and can snap if overtightened so just be careful when installing.

excellent