Tube Extrusion Tool - Efficient RTV and Silicone Dispenser That maximizes The use of All Material in The Tube and Prevents Material Waste(RED)

Great dispenser not flimsy bendy steel like I assumed. about 2mm thick all around. Only complaint like everyone is that it does tend to come apart easily if opened too much. Got myself two one for the service truck and one for the shop, no more monstrosities like the tubes I have uploaded

Why did you pick this product vs others?:Great for any rtvs or sealants! Use it for oil pan gaskets, timing covers, Honda eps recalls.

I bought the original Valco 'squeezer' decades ago. Yes, it worked great, but I wasn't thrilled about the design.I just got this model and it's a HUGE improvement, since it stays together!Great!

MY HANDS WERE GETTING TIRED AND HURTING FROM SQUEEZING TUBES OF DAP, SO I BOUGHT THIS TO HELP ME AND I SWEAR, IT JUST DOES NOT WORK. I HAVE TRIED IT EVERY WAY I CAN THINK OF AND IT WAS JUST A REALLY BAD PURCHASE ON MY PART. IF THE COMPANY WOULD TAKE IT BACK NOW AND GIVE MY MONEY BACK. I WOULD DO IT!

Works great!

As described in earlier reviews, it flew apart while unpacking. A minor irritant as it fits back together almost effortlessly. As delivered it is a good labor-saving tool with some minor problems. When using to lay a bead of stiff caulk the calk tube tends to ride out of the jaws and allow some caulk to seep back into the bottom of the tube. It's easy to squeeze the caulk back into the main part of the tube and applying a strip of 120 grit sticky back sandpaper to the bottom jaw stops the tube slippage and seeping allowing for a much easier application of stiff caulk/sealer. It is overpriced for what it is, unfortunately there's no readily available alternative cheaper or without more faults. Glad I bought it.

This was not really a good investment. It pops out of place frequently. I’m unable to use it most of the time I end up needing my husband to adjust it over and over very disappointed.

No waste better control no mess