BeastronRemote Control Outlet Switch Power Plug in for Household Appliances, Wireless Light Switch, Up to 100 ft. Range, Fcc Certified, ETL Listed, White (Learning Code, 5RX-2TX)

Difficult to plug in a second device when installed.Should have a better design to accommodate a typical receptical.

So easy to use and work great

My first set worked well, but did not last as long as I had hoped. Purchased again as priced decent, and hope for better longevity.

I am a senior citizen and with two controls these work great!

Loved these! So great for Christmas time! Bought a set for my mom too. :)

Everything is good except the size of the adapter it's a little bit bulky.

I configured all outlets as described in product instructions with one remote controller. What I didn't know until later because the outlets were located in different rooms, was that other outlets were turning on and off along with the one I was looking at. I put all outlets in the same room and tried multiple times to configure them as required. Since all were in the same room, I was able to see that in some cases more than 1 outlet was turning on and off.I used the second controller and was able to configure all 5 outlets without any problems. The first controller is defective so now I am trying to get in touch with Beastron. There is no phone number to call. The box does have a web address and I was able to send a note through the web site. If I don't get a response soon, I will simply return the whole package back to Amazon as defective.Update 4-20-2018I will not have to return the switches because I figured out the issue. Each remote controller is unique and each outlet has to be programed with both remotes. This can create a problem if buttons and outlets are mixed during the programming with each remote (my case). The reset function is not described in the 1 page instructions.1. Unplug all outlets from the wall outlets.2. Reset all outlets by holding down the program button while unplugged and continue holding down the program button while plugging it back into the wall outlet.3. The light will blink fast 4 times and then stay off.4. Do this to the next until all outlets have been reset.5. Start with outlet [1]. Press the program button on the outlet until it starts to blink slowly.6. Press button [1] on the 1st remote controller (not numbered) and the outlet will stop blinking. It is now programed.7. Repeat step 4 and 5 to the remaining outlets using corresponding outlet and buttons (1=1, 2=2, 3=3, 4=4, 5=5).8. Using the 2nd (not numbered) remote controller, repeat steps 4, 5, and 6 for all outlets.9. 1st and 2nd remote controllers have now been programmed so that buttons and outlets match. (1=1, 2=2, 3=3, 4=4, and 5=5).

Easy to use