EE01-BK- BLACK - Car/Bike Engine Enamel Paint - 250ml

I needed to paint a large 4 litre engine block on my classic car. With the proper preparation this stuff goes on superbly. Doesn't need a primer, although I used one anyway (Smoothrite). The gloss finish leaves no brush marks or runs and looks very thick. Time will tell, but I am pretty impressed so far. Don't buy more than you need. My 250mm tin is still half full having done the engine and gearbox. Only needs one coat too.

Paints well and leaves good durable finish

This is very good paint.. Drys very smooth & good shine..

Gives a good finish. Needs at least a couple of coats since the paint is quite thin.No indication on box or tin as to what is best to use to clean brushes.

Does exactly what it says on the tin

In my opinion I've never used worse paint.Its an absolute nightmare. It covers poorly and then it runs. I've tried everything and I'm now sanding it down for the 3rd time. On a smooth sump its impossible to stop runs. The only bit the works is the bits sitting flat. I've wasted days, not hours working with this rubbish.As for longevity mine only lasts 2 days coz I have to keep sanding it off to get rid of runs to try again. It also won't blend in again, their is a big linr were you stop.

Small tin but i painted a 6 cylinder cast iron bmw block and after one coat you could barely tell any had been used. Covered so well with one coat that i decided not to bother with another.Cant comment on heat resistance as its not been fired up yet, but will update this review if it all falls off in a week.

Wasn't sure 250ml would be enough but three coats to complete an engine paint with some over, great.